LF198 Precision Sample and Hold Amplifier

The LF198 is a precision sample and hold amplifier which uses a combination of bipolar and junction FET transistors to provide precision, high speed, and long hold times. A typical offset voltage of 1mV and gain error of 0.002% allow this sample and hold amplifier to be used in 12-bit systems. Dynamic performance can be optimized by proper selection of the external hold capacitor. Acquisition times can be as low as 4µs for small capacitors while hold step and droop errors can be held below 0.1mV and 30µV/sec respectively when using larger capacitors. The LF198 is fixed at unity gain with 1010 ohms input impedance independent of sample/hold mode. The logic inputs are high impedance differential to allow easy interfacing to any logic family without ground loop problems. A separate offset adjust pin can be used to zero the offset voltage in either the sample or hold mode. Additionally, the hold capacitor can be driven with an external signal to provide precision level shifting or "differencing" operation. The device will operate over a wide supply voltage range from ±5V to ±18V with very little change in performance, and key parameters are specified over this full supply range. The LF198A version offers tightened electrical specifications for key parameters

产品特点 Features

Guaranteed 6µs Max. Acquisition Time
Guaranteed 0.005% Max. Gain Error
Guaranteed 1mV Max. Offset Voltage
Guaranteed 1mV Max. Hold Step
Very Low Feedthrough 86dB Min.
High Input Impedance under All Conditions
Logic Inputs Compatible with All Logic Families

参数

应用

12-Bit Data Acquisition Systems
Ramp Generators
Analog Switches
Staircase Generators
Sample and Difference Circuits
Cellular Telephones

典型应用图

LF198 数据手册及相关资料下载

数据手册 (英文) : LF198/LF398 - Precision Sample and Hold Amplifier.PDF
可靠性数据 : R019 Reliability Data .PDF