产品特点 Features

AUX MUX 2 : 1 switch

• This 2 : 1 switch is controlled by CA_DET signal multiplexing of the 1 Mbit/s differential AUX and DDC (Direct Display Control) signals
  • When CA_DET is HIGH, DDC path is selected
• Differential AUX channel:
  • Low insertion loss: -0.5 dB at 5 MHz
  • Low return loss: -19 dB at 5 MHz
  • Low ON-state resistance: 7.5 Ω
  • Bandwidth: 5 GHz
  • Low off-state isolation: -75 dB at 5 MHz
  • Low crosstalk: -40 dB at 5 MHz
  • Common-mode input voltage VIC: 0 V to 3.3 V
  • Differential input voltage VID: 1.4 V (maximum)
• DDC channel has DDC_CLK and DDC_DAT I²C signals
  • 100 kHz 3.3 V voltage swing
• Both AUXIO+ and AUXIO- outputs have 900 Ω (±20 %) pull-down resistor that is enabled by the status of the BIASOUT output pin
  • These pull-down resistors provide DC bias for the 10 Gbit/s channel

DP MUX 2 : 1 switch

The DP MUX is a 2:1 switch that is controlled by DP_PD pin multiplexing of a differential DPML signal and LSTX/LSRX signals

• The DPML (DisplayPort Main Link) runs up to HBR2 data rate of 5.4 Gbit/s
• The low speed DC coupled signals LSTX and LSRX are 3.3 V single-ended signals that operated at 1 Mbit/s
• 5.4 Gbit/s DPML channel:
  • Low insertion loss for DP-DPMLO path: -2.0 dB at 2.5 GHz
  • Low insertion loss for LS-DPMLO path: -2.0 dB at 2.5 GHz
  • Low return loss for DP-DPMLO path: -15 dB at 2.5 GHz
  • Low return loss for LS-DPMLO path: -14 dB at 2.5 GHz
  • Low ON-state resistance for DP-DPMLO path: 9 Ω
  • Low ON-state resistance for LS-DPMLO path: 13 Ω
  • High bandwidth: 7 GHz
  • Low off-state isolation: -20 dB at 2.5 GHz
  • Low crosstalk: -25 dB at 2.5 GHz
  • Common-mode input voltage VIC: 0 V to 3.3 V
  • Differential input voltage VID: 1.4 V (maximum)

General

• The input of the HPDOUT (Hot Plug Detect output) buffer is 5 V tolerant
• HPDOUT, CA_DETOUT and BIASOUT buffers
  • CA_DET input leakage current < 0.1 μA to prevent driving the 1 MΩ pull-down to a HIGH level
  • BIASOUT buffer is able to provide enough current to drive the bias circuit for the PIN diode path
  • BIASOUT buffer can drive up to six sets of bias circuits for the 10 Gbit/s paths
• When AUXIO_EN is LOW or (BIASIN = 0 and DP_PD = 1), this chip is in Sleep mode
  • AUXIO+ and AUXIO- of AUX MUX are disabled
  • CA_DETOUT and HPDOUT buffers are on
  • When the chip is in Sleep mode, CBTL05023 will consume < 3.5 mW
• Patent-pending high-bandwidth analog pass-gate technology
• Very low intra-pair differential skew (5 ps typical)
• All channels have back current protection
• All channels support rail-to-rail input voltage
• CMOS input buffer with hysteresis
• Single 3.3 V ± 10 % power supply
• HVQFN24 3 mm x 3 mm package, 0.4 mm pitch, with exposed center pad for thermal relief and electrical ground
• ESD: 2500 V HBM, 1250 V CDM
• Operating temperature range: 0 °C to 85 °C

产品实物图