SC18IM700IPW Master I²C-bus controller with UART interface
The SC18IM700 is designed to serve as an interface between the standard UART port of a microcontroller or microprocessor and the serial I²C-bus; this allows the microcontroller or microprocessor to communicate directly with other I²C-bus devices. The SC18IM700 can operate as an I²C-bus master. The SC18IM700 controls all the I²C-bus specific sequences, protocol, arbitration and timing. The host communicates with SC18IM700 with ASCII messages protocol; this makes the control sequences from the host to the SC18IM700 become very simple
产品特点 Features
- UART host interface
- I²C-bus controller
- Eight programmable I/O pins
- High-speed UART: baud rate up to 460.8 kbit/s
- High-speed I²C-bus: 400 kbit/s
- 16-byte TX FIFO
- 16-byte RX FIFO
- Programmable baud rate generator
- 2.3 V and 3.6 V operation
- Sleep mode (power-down)
- UART message format resembles I²C-bus transaction format
- I²C-bus master functions
- Multi-master capability
- 5 V tolerance on the input pins
- 8 N 1 UART format (8 data bits, no parity bit, 1 stop bit)
- Available in very small TSSOP16 package
|
应用
- Enable I²C-bus master support in a system
- I²C-bus instrumentation and control
- Industrial control
- Medical equipment
- Cellular telephones
- Handheld computers
产品实物图
|
封装
| 型号 |
可订购的器件编号 |
订购码 (12NC) |
产品状态 |
封装 |
| SC18IM700IPW |
9352 806 29128 |
SC18IM700IPW,128 |
量产 |
TSSOP16
(SOT403-1) |
| SC18IM700IPW |
9352 806 29112 |
SC18IM700IPW,112 |
量产 |
TSSOP16
(SOT403-1) |
订货和供应
| 型号 |
订购码 (12NC) |
可订购的器件编号 |
化学成分 |
| SC18IM700IPW |
9352 806 29128 |
SC18IM700IPW,128 |
SC18IM700IPW |
| SC18IM700IPW |
9352 806 29112 |
SC18IM700IPW,112 |
SC18IM700IPW |
SC18IM700IPW 技术支持
| 档案名称 |
标题 |
类型 |
格式 |
| SC18IM700IPW |
Master I²C-bus controller with UART interface |
Data sheet |
pdf |
| AN10587 |
Interfacing NXP bridge IC with NXP ARM microcontroller
|
Application note |
pdf |
| AN10417 |
SC16IS760/762 Fast IrDA mode
|
Application note |
pdf |
| AN10428 |
UART-SPI Gateway for Philips SPI slave bridges
|
Application note |
pdf |
| AN10462 |
SPI programming for Philips Bridge ICs
|
Application note |
pdf |
| AN10485 |
SDA pin connection in SPI mode
|
Application note |
pdf |
| AN10486 |
Automatic RS-485 address detection
|
Application note |
pdf |
| AN10571 |
Sleep programming for NXP bridge ICs
|
Application note |
pdf |
| AN10452 |
Interfacing Philips Bridge IC with Philips microcontroller
|
Application note |
pdf |
| 75015676 |
Low-power bridges for I2C or SPI to UART or IrDA or GPIO; NXP low-power bridges SC16IS750/52/60/62
|
Leaflet |
pdf |
