The TJA1020 is the interface between the LIN master/slave protocol controller and the physical bus in a Local Interconnect Network (LIN). It is primarily intended for in-vehicle sub-networks using baud rates from 2.4 up to 20 Kbaud.
The transmit data stream of the protocol controller at the TXD input is converted by the LIN transceiver into a bus signal with controlled slew rate and wave shaping to minimize EME. The LIN bus output pin is pulled HIGH via an internal termination resistor. For a master application an external resistor in series with a diode should be connected between pin INH or pin BAT and pin LIN. The receiver detects the data stream at the LIN bus input pin and transfers it via pin RXD to the microcontroller.
In normal transceiver operation the TJA1020 can be switched in the normal slope mode or the low slope mode. In the low slope mode the TJA1020 lengthens the rise and fall slopes of the LIN bus signal, thus further reducing the already very low emission in normal slope mode.
In sleep mode the power consumption of the TJA1020 is very low, whereas in failure modes the power consumption is reduced to a minimum
产品特点 FeaturesGeneral
Low power management
Protections
|
功能框图 |
型号 | 订购码 (12NC) | 可订购的器件编号 | 产品状态 | 封装 |
TJA1020T/CM | 9352 950 78118 | TJA1020T/CM,118 | 量产 | SO8 (SOT96-1) |
型号 | 订购码 (12NC) | 可订购的器件编号 | 化学成分 |
TJA1020T/CM | 9352 950 78118 | TJA1020T/CM,118 | TJA1020T/CM |
档案名称 | 标题 | 类型 | 格式 |
TJA1020T | LIN transceiver | Data sheet | |
AN10115 | Philips Microcontrollers in LIN Applications | Application note | |
AN00093 | TJA1020 LIN Transceiver | Application note | |
AN00094 | TJA1041/1041A high speed CAN transceiver | Application note | |
AN00020 | TJA1050 high speed CAN transceiver | Application note | |
AN10211 | TJA1040 high speed CAN transceiver | Application note | |
AN96116 | PCA82C250/251 CAN Transceiver | Application note | |
PCA82C250_251_TJA1040_TJA1050 | Upgrading Note PCA82C250/251 -> TJA1040, TJA1050 | Other type |