STEVAL-IHT003V1 Low-loss e-Starter for compressors based on ACST6-7ST and X0205NN
The e-STARTER demonstration board represents an innovative solution patented by STMicroelectronics to reduce the power losses caused by positive temperature coefficient (PTC) resistors in compressor starter circuits.
The solution features an ACST6 AC switch device which is used to turn off the PTC current after motor start-up. It should be noted that the traditional PTC is still used in the electronic starter circuit, as it increases the safety of the circuit in cases of AC switch short-circuit or diode mode failure (ref. EN60335-1).
The design allows the starter standby losses to be reduced from (typ) 2.5 W to 380 mW for 230 V applications, or 2.5 W to 40 mW for 100 V applications.
Because this board is not a "plug and play" solution, prior to using the board with a compressor the PTC behavior must be checked (especially VPTC1 & VPTC2 levels), and different R4 resistor value may be required.
技术特性
- Suitable for refrigerator and freezer compressor applications
- Reduces PTC resistor power losses
| 功能框图
 |
STEVAL-IHT003V1 订购信息
| 订购型号 |
产品状态 |
美金价格 |
数量 |
封装 |
包装形式 |
温度范围 |
材料声明 |
| STEVAL-IHT003V1 |
Active |
|
1000 |
|
|
|
|
DATA BRIEF
| 描述 |
版本 |
大小 |
| STEVAL-IHT003V1 : DB0647: Low-loss e-STARTER demonstration board for compressor starter circuits based on the ACST6 |
1 |
71KB |
USER MANUALS
| 描述 |
版本 |
大小 |
| UM0575: STEVAL- IHT003V1, e-STARTER demonstration board based on the ACST6 and X02 |
1 |
725KB |
BILL OF MATERIALS
SCHEMATIC PACKS
PCB LAYOUTS
