STEVAL-TLL008V2 Camera flash with SuperCap daughterboard based on the STCF04
The STEVAL-TLL008V2 demonstration board is a daughterboard working in conjunction with the STEVAL-TLL008V1 and was designed to demonstrate the performance of the STCF04 device, which is a buck-boost converter with an I²C interface dedicated to charging a SuperCap™.
All LEDs with a forward voltage range from 2.5 V to 5 V are compatible with the STCF04. The forward voltage spread of any selected LED must, however, be within this range (2.5 V to 5 V).
It is possible to set the level of the LED current in Flash mode and torch mode by setting the dimming registers.
The maximum level of the LED current in Flash mode can be set by changing the external flash resistor
技术特性
- 1.8 MHz buck-boost converter with 1.2 A peak
- Current limiting and synchronous rectification
- Programmable current limit
- Burst mode operation when output is charged
- Selectable 200 mA / 400 mA SuperCap™ charging current
- Input voltage range 2.7 V to 5.5 V
- Programmable output charging voltage up to 5.5 V
- Full I²C control
- Controlled LED current in all modes
- Shorted LED failure detection and protection
- RoHS compliant
| 功能框图
 |
STEVAL-TLL008V2 订购信息
| 订购型号 |
产品状态 |
美金价格 |
数量 |
封装 |
包装形式 |
温度范围 |
材料声明 |
| STEVAL-TLL008V2 |
Preview |
|
1000 |
|
|
|
|
DATA BRIEF
| 描述 |
版本 |
大小 |
| STEVAL-TLL008V2 : DB1652: Camera flash with SuperCap™ daughterboard based on the STCF04 |
1 |
255KB |
APPLICATION NOTES
| 描述 |
版本 |
大小 |
| AN3424: STEVAL-TLL008V2: high power factor flyback LED driver based on the L6562A and TSM101 |
1 |
2299KB |
| AN3991: How to drive multiple stepper motors with the L6470 motor driver |
1 |
1760B |
BILL OF MATERIALS
SCHEMATIC PACKS
PCB LAYOUTS
