STM32F105xx和STM32F107xx互联型产品系列整合了工作频率为72MHz的高性能ARM ®Cortex™-M3 32位RISC内核、高速嵌入式存储器(256KB Flash存储器和64KB SRAM)，和大量连至2条APB总线的增强型I/O与外设。 所有器件均带有2个12位ADC、4个通用16位定时器和1个PWM定时器，以及标准与高级通信接口：2个I²C、3个SPI、2个I2S、5个USART、1个全速USB OTG和2个CAN。 只有STM32F107xx支持以太网。
STM32F105xx和STM32F107xx互联型产品系列的工作温度范围是–40~+105°C，供电电压为2.0~3.6V。 为低功耗应用设计提供了一组完整的节电模式。
STM32F105xx和STM32F107xx互联型产品系列提供从64引脚至100引脚，共3种不同的封装选项。 不同的型号，包含的外设组合也不同。该系列产品的外设组合如下所述。
这些特性让STM32F105xx和STM32F107xx互联型微控制器产品系列成为各种应用的理想之选，例如电机驱动和应用控制、医疗和手持式设备、工业应用、PLC、逆变器、打印机、扫描仪、警报系统、视频电话、HVAC和家庭音响设备。
技术特性
- 内核：ARM 32位Cortex™-M3 CPU
- 72 MHz maximum frequency, 1.25 DMIPS/MHz (Dhrystone 2.1) performance at 0 wait state memory access
- Single-cycle multiplication and hardware division
- 存储器
- 64 to 256 Kbytes of Flash memory
- 64 Kbytes of general-purpose SRAM
- 时钟、复位和电源管理
- 2.0 to 3.6 V application supply and I/Os
- POR, PDR, and programmable voltage detector (PVD)
- 3-to-25 MHz crystal oscillator
- Internal 8 MHz factory-trimmed RC
- Internal 40 kHz RC with calibration
- 32 kHz oscillator for RTC with calibration
- 低功耗
- Sleep, Stop and Standby modes
- VBAT supply for RTC and backup registers
- 2个12位、1μs A/D转换器(多达16通道)
- Conversion range: 0 to 3.6 V
- Sample and hold capability
- up to 2 MSPS in interleaved mode
- 2个12位D/A转换器
- DMA：12通道的DMA控制器
- Supported peripherals: timers, ADCs, DAC, I2Ss, SPIs, I²Cs and USARTs
- 调试模式
- Serial wire debug (SWD) & JTAG interfaces
- Cortex-M3 Embedded Trace Macrocell™
- 多达80个高速I/O端口
- 51/80 I/Os, all mappable on 16 external interrupt vectors and almost all 5 V-tolerant
- CRC计算单元、96位唯一ID
- 多达10个具有管脚重映射功能的定时器
- Up to four 16-bit timers, each with up to 4 IC/OC/PWM or pulse counter and quadrature (incremental) encoder input
- 1 × 16-bit motor control PWM timer with dead-time generation and emergency stop
- 2 × watchdog timers (Independent and Window)
- SysTick timer: a 24-bit downcounter
- 2 × 16-bit basic timers to drive the DAC
- 多达14个具有管脚重映射功能的通信接口
- Up to 2 × I²C interfaces (SMBus/PMBus)
- Up to 5 USARTs (ISO 7816 interface, LIN, IrDA capability, modem control)
- Up to 3 SPIs (18 Mbit/s), 2 with a multiplexed I2S interface that offers audio class accuracy via advanced PLL schemes
- 2 × CAN interfaces (2.0B Active) with 512 bytes of dedicated SRAM
- USB 2.0 full-speed device/host/OTG controller with on-chip PHY that supports HNP/SRP/ID with 1.25 Kbytes of dedicated SRAM
- 10/100 Ethernet MAC with dedicated DMA and SRAM (4 Kbytes): IEEE1588 hardware support, MII/RMII available on all packages
|
功能框图
 |
| 描述 |
版本 |
大小 |
| AN3156: USB DFU protocol used in the STM32™ bootloader |
2 |
246KB |
| AN3354: STM32F105/107 in-application programming using a USB host |
1 |
97KB |
| AN3154: CAN protocol used in the STM32™ bootloader |
3 |
379KB |
| AN2812: Vocoder demonstration using a Speex audio codec on STM32F101xx and STM32F103xx microcontrollers |
2 |
257KB |
| AN2784: 使用大容量STM32F10xxx的FSMC 驱动外部的存储器 |
1 |
716KB |
| AN2784: Using the high-density STM32F10xxx FSMC peripheral to drive external memories |
4 |
299KB |
| AN2790: TFT LCD interfacing with the high-density STM32F10xxx FSMC |
2 |
823KB |
| AN2945: STM8S and STM32™ MCUs: a consistent 8/32-bit product line for painless migration |
1 |
213KB |
| AN2606: STM32™ microcontroller system memory boot mode |
14 |
877KB |
| AN3078: STM32™ in-application programming over the I²C bus |
1 |
671KB |
| AN3116: STM32™'s ADC modes and their applications |
1 |
236KB |
| AN4023: STM32 secure firmware upgrade (SFU) overview |
1 |
41KB |
| AN3429: STM32 proprietary code protection overview |
1 |
61KB |
| AN4013: STM32F1xx, STM32F2xx, STM32F4xx, STM32L1xx timer overview |
1 |
200KB |
| AN2824: STM32F10xxx I²C optimized examples |
4 |
123KB |
| AN2868: STM32F10xxx internal RC oscillator (HSI) calibration |
1 |
189KB |
| AN2557: STM32F10x in-application programming using the USART |
8 |
215KB |
| AN2629: STM32F101xx, STM32F102xx and STM32F103xx low-power modes |
2 |
496KB |
| AN2639: Soldering recommendations and package information for Lead-free ECOPACK® microcontrollers |
2 |
209KB |
| AN1015: Software techniques for improving microcontroller EMC performance |
1 |
105KB |
| AN2598: 使用STM32F101xx和STM32F103xx的智能卡接口 |
2 |
651KB |
| AN2598: Smartcard interface with the STM32F10x microcontrollers |
3 |
501KB |
| AN2867: Oscillator design guide for STM8S, STM8A, and STM32F1 microcontrollers |
6 |
280KB |
| AN3422: Migration of microcontroller applications from STM32F1 to STM32L1 series |
2 |
312KB |
| AN3364: Migration and compatibility guidelines for STM32 microcontroller applications |
3 |
128KB |
| AN4088: Migrating from STM32F1 to STM32F0 |
1 |
919KB |
| AN3427: Migrating a microcontroller application from STM32F1 to STM32F2 series |
1 |
377KB |
| AN3070: Managing the Driver Enable signal for RS-485 and IO-Link communications with the STM32™’s USART |
1 |
192KB |
| AN3174: Implementing receivers for infrared remote control protocols using STM32F10xxx microcontrollers |
2 |
592KB |
| AN2953: How to migrate from the STM32F10xxx firmware library V2.0.3 to the STM32F10xxx standard peripheral library V3.0.0 |
1 |
1251KB |
| AN2834: 如何在STM32F10xxx上得到最佳的ADC精度 |
1 |
610KB |
| AN3307: Guidelines for obtaining IEC60335 Class B certification in any STM32F1xx application |
2 |
340KB |
| AN2586: STM32F10xxx硬件开发使用入门 |
2 |
682KB |
| AN2586: Getting started with STM32F10xxx hardware development |
7 |
417KB |
| AN1709: EMC design guide for ST microcontrollers |
1 |
657KB |
| AN1181: Electrostatic discharge sensitivity measurement |
1 |
59KB |
| AN2594: EEPROM emulation in STM32F10x microcontrollers |
3 |
156KB |
| AN3109: Communication peripheral FIFO emulation with DMA and DMA timeout in STM32F10x microcontrollers |
1 |
110KB |
| AN3126: Audio and waveform generation using the DAC in STM32 microcontroller families |
1 |
648KB |
| 描述 |
版本 |
大小 |
| UM0424: STM32 USB-FS-Device development kit |
11 |
1175KB |
| UM0462: STM32™ and STM8™ Flash loader demonstrator |
7 |
1673KB |
| UM1053: Advanced developers guide for STM32F100x/103x/2x/40x/41x MCUs PMSM single/dual FOC library |
3 |
874KB |
| UM0494: STM32 PerformanceStick interconnection board |
1 |
93KB |
| UM1052: STM32F103xx/ STM32F100xx/STM32F2xx/STM32F4xx PMSM single/dual FOC SDK v3.2 |
3 |
2724KB |
| UM0574: STEVAL-ILL015V1 - LED dimmer demonstration board based on the STP24DP05 and STM32邃｢ |
1 |
662KB |
| UM0412: Getting started with DfuSe USB device firmware upgrade STMicroelectronics extension |
4 |
465KB |
| UM1029: Communication peripheral application library (CPAL) |
2 |
549KB |
| UM0685: CEC (consumer electronic control) C library using the STM32F101xx, STM32F102xx and STM32F103xx microcontrollers |
3 |
874KB |
| Part Number |
描述 |
| STM-STUDIO |
STM Studio run-time variables monitoring and visualization tool |
| STM320518-EVAL |
Evaluation board for STM32 F0 series - with STM32F051 MCU |
| STVP |
ST Visual Programmer for programming ST7, STM8, STM8T and STM32 |
| STM32F0DISCOVERY |
Discovery kit for STM32 F0 series - with STM32F051 MCU |
| ST-LINK |
In-circuit debugger and programmer for STM8 and STM32 MCUs; with IAR EWARM and Keil RVMDK and ST toolset |
| STX-PRO/RAIS |
Unlimited in-circuit debugging/programming tool for STM32, STR7 and STR9 |
| MicroXplorer |
MCU graphical configuration tool |
| ST-LINK/V2 |
ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 |
| STX-RLINK |
In-circuit debugger/programmer supporting JTAG and ICC protocols for STM8, ST7, uPSD, STM32, STR7 and STR9 microcontrollers |
