The VNQ6040S-E is a device made using STMicroelectronics®VIPower®technology. It is intended for driving resistive or inductive loads directly connected to ground. The device is protected against voltage transient on VCCpin.
Programming, control and diagnostics are implemented via the SPI bus.
An analog current feedback for each channel is connected to the CURRENT-SENSE pin via a multiplexer. A CS_SYNC pin delivers a synchronous signal for sampling the current sense while the corresponding output is on.
The device detects open-load for both on-state and off-state conditions.
Real time diagnostic is available through the SPI bus (open-load, output short to VCC, overtemperature, communication error).
Output current limitation protects the device in an overload condition. The device can limit the dissipated power to a safe level up to thermal shutdown intervention. Thermal shutdown can be configured as latched off or with automatic restart.
The device enters a limp home mode in case of loss of digital supply (VDD), reset of digital memory or CSN monitoring time-out event. In this mode states of channel 0, 1, 2 or 3 are respectively controlled by four dedicated pins IN0, IN1, IN2 and IN3. Each channel can be programmed in BULB/LED mode.
技术特性
|
功能框图 |
订购型号 | 产品状态 | 美金价格 | 数量 | 封装 | 包装形式 | 温度范围 | 材料声明 |
VNQ6040S-E | Active | 3.935 | PWSSO 36 | Tube | VNQ6040S-E | ||
VNQ6040STR-E | Active | 3.935 | PWSSO 36 | Tape And Reel | VNQ6040STR-E |
描述 | 版本 | 大小 |
VNQ6040S-E : DS6984: Quad channel high-side driver | 5 | 1002KB |