• 简体中文
• English

LT1509 - Power Factor and PWM Controller

The LT®1509 is a complete solution for universal off-line switching power supplies utilizing active power factor correction. The PFC section is identical to the LT1248 PFC controller except the EN/SYNC pin is removed because PFC and PWM are synchronized internally. The current mode PWM section (the LT1508 is the volt-age-mode counterpart) contains all the primary side functions to convert the PFC preregulated high voltage output to an isolated low voltage output. The PWM duty cycle is internally limited to 47% (maximum 50%) to prevent transformer saturation. PWM soft start begins when PFC output reaches the preset voltage. In the event of brief line loss,the PWM will be shut off when the PFC output voltage drops below 73% of the preset value.

特点 PFC and PWM Single Chip Solution Synchronized Operation up to 300kHz 99% Power Factor over 20:1 Load Current Range Current Mode PWM Instantaneous Overvoltage Protection Dedicated Overvoltage Protection (OVP Pin) Minimal Line Current Dead Zone Typical 250µA Start-Up Supply Current Line Switching Noise Filter Low Quiescent Current: 13mA Fast 2A Peak Current Gate Drivers Separate Soft Start Controls 典型应用

应用 Universal Power Factor Corrected Power Supplies and Preregulators 封装信息