• 简体中文
• English

MCP6SX2DM-PCTLPD MCP6SX2 PGA Photodiode PICtail Demo Board

The MCP6SX2 PGA Photodiode PICtail™ Demo Board features a PNZ334 photodiode, MCP6001U op amp, and MCP6S22 and MCP6S92 Programmable Gain Amplifiers (PGA).

The op amp converts the photodiode’s output current to voltage (transimpedance amplifier). Its output goes to one of the PGA’s inputs. The other PGA input is available for any other desired source. This opens the possibilities of processing other sensor signals, and of increasing the number of PIC® microcontroller I/O pin available for other purposes.

This board works with the PICkit™ 1 Flash Starter Kit (see DS40051) and the Signal Analysis PICtail™ Daughter Board (see DS51476). With these additional tools, a complete solution is achieved: PC software interface, PICmicro® microcontroller, firmware programmability, 10-bit ADC (on the microcontroller), and firmware (with re-locatable assembler code) for the microcontroller.

PGA

文档资料与软件下载

AppNotes	Last Updated	Size
AN951 - Amplifying High-Impedence Sensors ? Photodiode Example	7/25/2006 3:03:40 PM	290KB
MCP6S21/2/6/8 Datasheet	2/5/2013 10:07:19 AM	724KB
MCP6001/R/U/2/4, 1 MHz, Low-Power Op Amp	11/18/2009 2:57:55 PM	775KB
MCP6S22 PGA Photo Diode PICtail Demo Board Gerbers	1/10/2006 4:17:33 PM	86KB
Design Spreadsheet	9/23/2005 11:11:48 AM	43KB
Photodiode PGA PICtail Daughter Board User's Guide	8/1/2005 1:21:42 PM	439KB
PICkit™ 1 FLASH Starter Kit User's Guide	1/21/2005 2:56:11 PM	1MB
Single-Ended, Rail-to-Rail I/O, Low-Gain PGA	10/20/2004 5:07:49 PM	690KB
MCP6S22 PGA PICtail Daughter Board User's Guide	10/6/2004 6:19:55 PM	439KB
Signal Analysis PICtail™ Daughter Board User's Guide	7/22/2004 2:17:43 PM	1MB