RN-1810-PICTAIL RN1810 Wi-Fi PICtail/PICtail Plus Daughter Board
Based on Microchip's new low power IEEE 802.11b/g/n Wi-Fi module the , the RN1810 PICtail™/ PICtail Plus Daughter Board allows customers to easily develop Wi-Fi applications using Microchip’s 8, 16 and 32-bit PIC® microcontrollers. The kit includes a fully integrated TCP/IP stack allowing for a simple serial to Wi-Fi connection to the microcontroller. The board features a USB interface for easy plug-and-play development with a PC. The board is also compatible with the Explorer 16 Development Board (), PICDEM.net2 Development Board () and PIC32 Starter Kit () with I/O Expansion Board ().
- Enables rapid development with the RN1810 low power 802.11b/g/n Wi-Fi module
- PICtail™ and PICtail Plus interfaces for connection to Microchip Explorer 16 (DM240001) , PIC32 I/O Expansion board (DM320002) or PIC18 Explorer (DM183032) development boards
- On-board USB to UART bridge for easy development from PC
- On-board connection and data status LEDs
- IEEE 802.11b/g/n Compliant Transceiver
- 2.4 GHz IEEE 802.11n Single Stream 1x1
- UART Interface to Host Controller (4-wire including RTS/CTS)
- Configured using Simple ASCII Commands
- Supports Infrastructure and SoftAp Networking Modes
- Built-In Networking Applications: IPv4/IPv6, TCP, UDP, DHCP, DNS, ICMP, ARP, HTTP, FTP, SNTP, and SSL/TLS
- Complete On-Board TCP/IP Networking
- Upgrade Firmware Over the Air using TFTP
- Supports Wi-Fi® Protected Setup (WPS)
- Modular Certified for the United States (FCC), Canada (IC), Europe, Australia, New Zealand, Korea, Taiwan, and Japan
文档资料与软件下载
| Documents | Last Updated | Size | |
|---|---|---|---|
| RN1810 PICtail/PICtail Plus Daughter Board User's Guide | 3/13/2016 11:39:45 PM | 1MB |
- RN1810 PICtail/PICtail Plus Daughter Board User's Guide RN-1810-PICTAIL
