TC4404

The TC4404 and TC4405 are CMOS buffer-drivers constructed with complementary MOS outputs, where the drains of the totem-pole output have been left separated so that individual connections can be made to the pull-up and pull-down sections of the output. This allows the insertion of drain-current-limiting resistors in the pull-up and/or pull-down sections, allowing the user to define the rates of rise and fall for a capacitive load; or a reduced output swing, if driving a resistive load, or to limit base current, when driving a bipolar transistor. Minimum rise and fall times, with no resistors, will be less than 30nsec for a 1000pF load. There is no upper limit. For driving MOSFETs in motor-control applications, where slow-ON/fast-OFF operation is desired, these devices are superior to the previously-used technique of adding a diode-resistor combination between the driver output and the MOSFET, because they allow accurate control of turn-ON, while maintaining fast turn-OFF and maximum noise immunity for an OFF device. When used to drive bipolar transistors, these drivers maintain the high speeds common to other Microchip drivers. They allow insertion of a base current-limiting resistor, while providing a separate half-output for fast turn-OFF. By proper positioning of the resistor, either npn or pnp transistors can be driven. For driving many loads in low-power regimes, these drivers, because they eliminate shoot-through currents in the output stage, require significantly less power at higher frequencies, and can be helpful in meeting low-power budgets. Because neither drain in an output is dependent on the other, these devices can also be used as open-drain buffer/drivers where both drains are available in one device, thus minimizing chip count. Unused open drains should be returned to the supply rail that their device sources are connected to (pull-downs to ground, pull-ups to VDD), to prevent static damage. In addition, in situations where timing resistors or other means of limiting crossover currents are used, like drains may be paralleled for greater current carrying capacity. These devices are built to operate in the most demanding electrical environments. They will not latch up under any conditions within their power and voltage ratings; they are not subject to damage when up to 5V of noise spiking of either polarity occurs on their ground pin; and they can accept, without damage or logic upset, up to 1/2 amp of reverse current (of either polarity) being forced back into their outputs. All terminals are fully protected against up to 2 kV of electrostatic discharge.

产品特性
  • Independently-Programmable Rise and Fall Times
  • Low Output Impedance: 7 ? Typ.
  • High Speed tR, tF: <30nsec with 1000pF Load
  • Short Delay Times: < 30nsec
  • Wide Operating Range: 4.5V to 18V
  • Latch-Up Protected: Will Withstand > 500mA
  • Reverse Current (Either Polarity)
  • Input Withstands Negative Swings Up to – 5V
技术参数
Parameter Name Value Value
MOSFET Driver Type Low Side Low Side
Driver Type Single Single
Configuration Inverting Inverting
Peak Output Current (source/sink, A) 1.5/1.5 1.5/1.5
Output Resistance (source/sink, Ω) 7/7 7/7
Maximum Supply Voltage (V) 18 18
Propagation Delay (Td1/Td2, ns) 40/60 40/60
Rise/Fall Time (Tr/Tf, ns) 40/40 40/40
Capacitive Load Drive 1000 pF in 30 ns 1000 pF in 30 ns
文档资料
TC4404/TC4405 Data SheetData Sheets04/12/2016877KB
01327A - Avoiding MOSFET Driver OverstressAppNote07/07/2010455KB
AN1256 - Microchip's Power MOSFET Driver Simulation ModelsAppNote03/10/2009158KB
AN763 - Latch-Up Protection for MOSFET DriversAppNote10/22/2009136KB
AN786 - Considerations for Driving Power MOSFETs in High-Current, Switch Mode RegulatorsAppNote11/12/2002202KB
AN799 - Matching MOSFET Drivers to MOSFETsAppNote08/03/2004182KB
AN898 - Determining MOSFET Driver Needs for Motor Drive ApplicationsAppNote12/31/2003512KB
Analog & Interface Guide (Volume 2)Brochures10/11/20051067KB
Quick Guide to Microchip Development ToolsBrochures10/15/201411223KB
Analog & Interface Product Selector GuideProduct Line Card03/21/20164116KB
SPICE Models for TC4404-05 MOSFET Driver DevicesSpice Model02/05/20135KB
8-Pin SOIC/MSOP/TSSOP/DIP Evaluation Board User's GuideUser Guides01/24/20061367KB
订购型号
Part NumberLeadsPackage TypeTemp RangePacking1+26+100+1000+5000+
TC4404COA8SOIC0C to +70CTUBE2.562.131.941.621.49
TC4404COA7138SOIC0C to +70CT/R2.562.131.941.621.49
TC4404CPA8PDIP0C to +70CTUBE2.642.202.001.671.54
TC4404EOA8SOIC-40C to +85CTUBE2.692.242.041.701.57
TC4404EOA7138SOIC-40C to +85CT/R2.692.242.041.701.57
TC4404EPA8PDIP-40C to +85CTUBE2.772.312.101.751.62
相关开发工具
器件无铅环保信息
PartNumberDeviceWeightShippingWeightLeadCountPackageTypePackageWidthSolderCompositionJEDECIndicatorRoHSChinaEFUP
TC4404CPA0.4867000.9000008PDIP.300inMatte Tine3
TC4404EPA0.4867000.9000008PDIP.300inMatte Tine3
TC4404EOA0.0780000.1600008SOIC.150In(3.90mm)Matte Tine3
TC4404EOA7130.0780000.2303038SOIC.150In(3.90mm)Matte Tine3
TC4404COA0.0780000.1600008SOIC.150In(3.90mm)Matte Tine3
TC4404COA7130.0780000.2303038SOIC.150In(3.90mm)Matte Tine3
TC4404/TC4405 Data Sheet TC4405
01327A TC4468
AN1256 TC4469
AN763 TC4627
AN786 TC4627
AN799 TC4467
AN898 TC4626
Analog & Interface Guide (Volume 2) MCP23S08
Quick Guide to Microchip Development Tools ENC28J60
Analog & Interface Product Selector Guide ENC624J600
SPICE Models for TC4404-05 MOSFET Driver Devices TC4405
8-Pin SOIC/MSOP/TSSOP/DIP Evaluation Board User's Guide SOIC8EV