AD8315 50 dB GSM PA Controller

The AD8315 is a complete low cost subsystem for the precise control of RF power amplifiers operating in the frequency range 0.1 GHz to 2.5 GHz and over a typical dynamic range of 50 dB. It is intended for use in cellular handsets and other batteryoperated wireless devices. The log amp technique provides a much wider measurement range and better accuracy than controllers using diode detectors. In particular, the temperature stability is excellent over a specified range of −30°C to +85°C.

Its high sensitivity allows control at low signal levels, thus reducing the amount of power that must be coupled to the detector.

For convenience, the signal is internally ac-coupled. This high-pass coupling, with a corner at approximately 0.016 GHz, determines the lowest operating frequency. Therefore, the source can be dc grounded.

The AD8315 provides a voltage output, VAPC, that has the voltage range and current drive to directly connect to most handset power amplifiers’ gain control pin. VAPC can swing from 250 mV above ground to within 200 mV below the supply voltage. Load currents of up to 6 mA can be supported.

The setpoint control input is applied to the VSET pin and has an operating range of 0.25 V to 1.4 V. The associated circuit determines the slope and intercept of the linear-in-dB measurement system; these are nominally 23 mV/dB and −60 dBm for a 50 Ω termination (−73 dBV) at 0.9 GHz. Further simplifying the application of the AD8315, the input resistance of the setpoint interface is over 100 MΩ, and the bias current is typically 0.5 μA.

The AD8315 is available in MSOP and LFCSP packages and consumes 8.5 mA from a 2.7 V to 5.5 V supply. When powered down, the sleep current is 4 μA.

Applications
  • Single, dual, and triple band mobile handset (GSM, DCS, EDGE)
  • Transmitter power control
Features and Benefits
  • Complete RF detector/controller function
  • >50 dB range at 0.9 GHz (-49 dBm to +2 dBm, re 50 Ω)
  • Accurate scaling from 0.1 GHz to 2.5 GHz
  • Temperature-stable linear-in-dB response
  • Log slope of 23 mV/dB, intercept at -60 dBm at 0.9 GHz
  • True integration function in control loop
  • Low power: 20 mW at 2.7 V, 38 mW at 5 V
  • Power-down to 10.8 µW
  • RF & Microwave
    Data Sheets
    Documentnote
    AD8315: 50 dB GSM PA Controller Data Sheet (Rev. D)PDF 439.91 K
    Application Notes
    Documentnote
    AN-653: Improving Temperature, Stability, and Linearity of High Dynamic Range RMS RF Power Detectors (Rev. A)PDF 415 kB
    Frequently Asked Questions
    Documentnote
    Order Information
    Part NumberPackagePacking QtyTemp RangePrice 100-499Price 1000+RoHS
    AD8315ACPZ-REEL7 ProductionLFCSP:LEADFRM CHIP SCALEREEL 3000-30 to 85C04Y
    AD8315ARMZ Production8 ld MSOPOTH 50-30 to 85C4.84Y
    AD8315ARMZ-RL Production8 ld MSOPREEL 3000-30 to 85C04Y
    Evaluation Boards
    Part NumberDescriptionPriceRoHS
    AD8315-EVALEvaluation Board-1N
    Reference Materials
    AD8315: 50 dB GSM PA Controller Data Sheet (Rev. D) ad8315
    AN-653: Improving Temperature, Stability, and Linearity of High Dynamic Range RMS RF Power Detectors (Rev. A) ad8314
    AN-653: 改善高动态范围均方根射频功率检波器的温度稳定性和线性度 (Rev. A) ad8314
    Design and Operation of Automatic Gain Control Loops for Receivers in Modern... ad8369
    RF Source Booklet adf9010
    Measurement and Control of RF Power, Part I ad640
    Measurement and Control of RF Power, Part II ad640
    Measurement and Control of RF Power, Part III ad640
    Log Amps and Directional Couplers Enable VSWR Detection ad640
    Measuring VSWR and Gain in Wireless Systems ad640
    Measuring the RF Power in CDMA2000 and W-CDMA High Power Amplifiers (HPAs) ad640
    Detecting Fast RF Bursts using Log Amps ad640
    Make Precise Base-Station Power Measurements ad640
    Design a Logamp RF Pulse Detector ad640