HMC7748 2 GHz to 6 GHz, 25 W Power Amplifier Module

The HMC7748 is a multistage power amplifier (PA) that provides 25 W of saturated output power across the band of 2 GHz to 6 GHz. It draws 0.7 A from a 12 V supply and up to 4 A from a 28 V supply. Input signals of as much as −8 dBm are acceptable, and the module has small signal gain of 60 dB. The 12 V supply is regulated internally and generates the negative voltage required for the gate bias. Built-in bias sequencing prevents the drain voltages for the amplifier stages from being applied without the negative voltage present, which protects the amplifiers if 28 V is applied without 12 V supply applied. An external enable pin causes the module to remain in shutdown mode unless the pin is pulled to ground. This pin provides a means of turning the amplifiers off and on without cycling the power supplies. Applications

Features and Benefits
  • 58 dB typical small signal gain
  • 43 dBm typical saturated output power
  • 48 dBm typical output IP3
  • 6 dB maximum noise figure
  • Operates from 12 V and 28 V supplies
  • Built-in bias sequencing
  • Enable pin to provide shutdown capability
  • RF & Microwave
    Aerospace and Defense
    • Solutions
    Data Sheets
    Documentnote
    HMC7748: 2 GHz to 6 GHz, 25 W Power Amplifier Module Data Sheet (Rev. PrB)PDF 252.85 K
    Application Notes
    Documentnote
    AN-1363: Meeting Biasing Requirements of Externally Biased RF/Microwave Amplifiers with Active Bias Controllers (Rev. 0)PDF 804.11 K
    Order Information
    Part NumberPackagePacking QtyTemp RangePrice 100-499Price 1000+RoHS
    HMC7748 Pre-ReleaseMODULE CONNECTORIZEDOTH 1-40 to 70C00N
    HMC7748: 2 GHz to 6 GHz, 25 W Power Amplifier Module Data Sheet (Rev. PrB) hmc7748
    AN-1363: 利用有源偏置控制器满足外部偏置射频/微波放大器的偏置要求 (Rev. 0) hmc8120
    AN-1363: Meeting Biasing Requirements of Externally Biased RF/Microwave Amplifiers with Active Bias Controllers (Rev. 0) hmc8120