TLE4253E

The TLE4253 is a monolithic integrated low-dropout voltage tracking regulator in small PG-DSO-8 packages. The exposed pad (EP) package variant PG-DSO-8 exposed pad offers extremely low thermal resistance. The IC is designed to supply off-board systems, e. g. sensors in engine management systems under the severe conditions of automotive applications. Therefore, the IC is equipped with additional protection functions against reverse polarity and short circuit to GND and battery. With supply voltages up to 40 V, the output voltage follows a reference voltage applied at the adjust input with high accuracy. The reference voltage applied directly to the adjust input or by an e. g. external resistor divider can be 2.0 V at minimum. The output is able to drive loads up to 250 mA at minimum while the device follows the e. g. 5 V output of a main voltage regulator acting as reference with high accuracy. The TLE4253 tracker can be set into shutdown mode in order to reduce the quiescent current to an extremly low value. This makes the IC suitable to low power battery applications.

ParametricTLE4253E
Operating Voltage  min  max3.5V  40.0V
Output Voltage Typeadj.
Accuracy0.5%
Output Current (max.)250mA
Regulator TypeLinear->Tracker
Dropout Voltage280mV
Quiescent Current120µA
Operating Temperature  min  max-40.0°C  150.0°C
Over Voltage Protectionno
Enable (=Inhibit)yes
Resetno
Power Failno
Power Goodno
Status Outputno
Holdno
Watchdogno
Early Warningno
Sales Product NameTLE4253E
OPNTLE4253EXUMA2
Product Statusactive and preferred
Package NamePG-DSO-8
Completely lead freeyes
Halogen freeyes
RoHS compliantyes
Packing Size2500
Packing TypeTAPE & REEL
Moisture Level3
OPNTLE4253EXUMA1
Product Statusactive and preferred
Package NamePG-DSO-8
Completely lead freeyes
Halogen freeyes
RoHS compliantyes
Packing Size2500
Packing TypeTAPE & REEL
Moisture Level3
Summary of Features:
  • Tight output tracking tolerance to reference
  • Output voltage adjust down to 2.0 V
  • Stable with ceramic output capacitor
  • Flexibility of output voltage adjust higher or lower than reference,proportional to the reference voltage
  • 250 mA output current capability
  • Low dropout voltage
  • Combined tracking / enable input
  • Very low current consumption in OFF mode
  • PG-DSO-8 packages with lowest thermal resistance
  • Wide input voltage range -42 V ≤ V I  ≤ 45 V
  • Wide temperature range: -40 °C ≤ T j  ≤ 150 °C
  • Output protected against short circuit to GND and battery
  • Overtemperature protection
  • Reverse polarity proof
  • Suitable for use in automotive electronics
  • Green Product (RoHS compliant)
  • AEC Qualified
Benefits:
  • Efficient and accurate voltage replication
  • Heat distribution in the system
  • Robust tracking supply
Target Applications:
  • Sensor Supply
  • Heat distribution
  • Secondary µcontroller supply
Diagrams
Data Sheet
TitleSizeDateVersion
TLE4253_DS_12,EN407 KB10 Dec 200901_02
Product Brochure
TitleSizeDateVersion
What the designer should know: introduction to Automotive Linear Voltage Regulator3.9 MB17 Jul 2014
Application Notes
TitleSizeDateVersion
TLE4267/TLE4267-2 - INH/HOLD FunctionEN244 KB27 Apr 201501_33
Product Selection Guide
TitleSizeDateVersion
Automotive Power Selection GuideEN10.6 MB19 Jan 201601_01
Material Content SheetInfo
TitleSizeDateVersion
MCDS_2015-10-07_02-59-33_MA001172466_PG-DSO-8-27.pdfEN27 KB07 Oct 201501_00
MCDS_2013-08-28_22-55-30_MA000970042_PG-DSO-8-27.pdf23 KB31 Oct 201301_00
PCB Design Data
TitleSizeDateVersion
PCB Footprints & Symbols - Altium - v1.03.6 MB02 Oct 201301_00
PCB Footprints & Symbols - Cadence - v1.02.6 MB02 Oct 201301_00
PCB Footprints & Symbols - Eagle - v1.0569 KB02 Oct 201301_00
PCB Footprints & Symbols - Mentor - v1.03.5 MB02 Oct 201301_00
Evaluation Boards
BoardFamilyDescriptionStatus
KIT_AK_SMALL_ENGINEHigh/Low Side Switch, Microcontroller, Motor Driver (F/H-Bridge), TransceiverThe Starter Kit for 1- / 2-Cylinder Combustion Engines includes: Small Engine Control Unit, MECTRONIK MECLAB™ configuration and calibration software, U-Connect XC2704 Interface Board USB-CAN and Cable HarnessBTS3410KP254TLE4253TLE6250TLE8080TLE8444XC2733active
TLS810C1EJV33 BOARDLinear Voltage RegulatorThe TLS810C1EJV33 is a linear voltage regulator of wide input voltage range, low drop out voltage and ultra low quiescent current. With an input voltage range of 2.75V to 42V and ultra low quiescent of only 8.5μA the regulators are perfectly suitable for automotive or any other supply systems connected permanently to the battery. The TLS810C1EJV33 is available in 3.3V output voltage version with an accuracy of 2 % and output current capability up to 100mA. It is stable with only a small ceramic capacitor of 1μF at the output. With extended operating range down to 2.75V, TLS810C1EJV33 is also suitable to supply automotive systems operating during cranking condition. TLS810C1EJV33 includes internal protection features like output current limitation and over-temperature shutdown. The output voltage is supervised by the Reset feature, including under-voltage reset and delayed reset release at power-on.Channel=ff80808112ab681d0112ab69bfb202efTLS810C1EJV33on request
TLS810D1EJV50 BOARDLinear Voltage RegulatorThe TLS810D1EJV50 is a linear voltage regulator featuring wide input voltage range, low drop out voltage and ultra low quiescent current. With an input voltage range of 2.75V to 42V and ultra low quiescent of only 9μA the regulators are perfectly suitable for automotive or any other supply systems connected permanently to the battery. The TLS810D1EJV50 is available in 5.0V output voltage version with an accuracy of 2 % and output current capability up to 100mA. It is stable with only a small ceramic capacitor of 1μF at the output. The device can be switched on and off by the Enable feature leading to a current consumption of less than 1μA. With extended operating range down to 2.75V, TLS810D1EJV50 is also suitable to supply automotive systems operating during cranking condition. TLS810D1EJV50 includes internal protection features like output current limitation and over-temperature shutdown. The output voltage is supervised by the Reset feature, including under-voltage reset and delayed reset release at power-on.TLS810D1EJV50on request
Package Data
TitleSizeDateVersion
PG-DSO-8-27 | TLE4253EXUMA1EN505 KB11 Apr 201601_00
PG-DSO-8-27 | TLE4253EXUMA2EN609 KB11 Apr 201601_00
PCB Design Data
TitleSizeDateVersion
PCB Footprints & Symbols - Altium - v1.03.6 MB02 Oct 201301_00
PCB Footprints & Symbols - Cadence - v1.02.6 MB02 Oct 201301_00
PCB Footprints & Symbols - Eagle - v1.0569 KB02 Oct 201301_00
PCB Footprints & Symbols - Mentor - v1.03.5 MB02 Oct 201301_00
EN TLE4253GS
What the designer should know: introduction to Automotive Linear Voltage Regulator linear-post-regulators
EN TLE42764D+V50
EN TLE8203E
EN TLE4253E
MCDS_2013-08-28_22-55-30_MA000970042_PG-DSO-8-27.pdf TLE4253E
EN TLE4253E
EN TLE4253E
PCB Footprints & Symbols - Altium - v1.0 IFX1763XEJ+V33
PCB Footprints & Symbols - Cadence - v1.0 IFX1763XEJ+V33
PCB Footprints & Symbols - Eagle - v1.0 IFX1763XEJ+V33
PCB Footprints & Symbols - Mentor - v1.0 IFX1763XEJ+V33