DC1368A - LT3080EDD-1 Demo Board | LT3080-1(x4), Paralleled, Single Resistor Prog Low Noise LDOs, 1.7V ≤ VIN ≤ 25V, Vout = 1.2V @ 4.4A
Demonstration circuit 1368A exercises four adjustable linear regulators in parallel using the LT3080-1, which incorporates an internal ballast resistor. The ballast resistor allows direct paralleling of devices without the need for PC board resistors or sensor resistors.The paralleled devices provide up to 4.4A of output current at 1.2V.
Architected as a precision current source and voltage follower, the LT3080-1 can be used in many applications requiring high current, adjustability to zero output, and no heat sink. The device brings out the collector of the pass transistor to allow low dropout operation when used with multiple supplies. The LT3080-1's output voltage can be programmed to any level between 0V and 36V; however the demo board has a reduced input voltage range from 1.7V to 25V due to the input capacitor voltage rating.
Demo Board Design File
Demo Board Manual
Demo Board Schematic
Products
Related Solutions
- Terasic C5G Cyclone V GX Starter Kit
- LT3080-1 Paralleling Regulators
- Altera Stratix IV GX FPGA Development Kit
- Altera Audio Video Development Kit, Stratix IV GX Edition
- Terasic TR5-Lite Stratix V FPGA Development Kit
- Terasic DE5-Net Stratix V Board
- Terasic TR4 Stratix IV Board
- Directly Parallel This High Power Density Linear Regulator - LT3080
- Loop Gain and its Effect on Analog Control Systems
- Paralleling Linear Regulators Made Easy
