MAX16802BEVKIT：Evaluation Kit for the MAX16802B
The MAX16802B evaluation kit (EV kit) demonstrates a
current-controlled, high-output-current LED driver
based on the MAX16802B. This EV kit is capable of
supplying stable output currents of up to 750mA, can
run at supply voltages between 10.8V and 30V, and can
operate at temperatures ranging from -40°C to +85°C.
The MAX16802B EV kit features two different types of
dimming controls using either a linear input voltage or a
PWM input signal to control the LED brightness. This EV
kit also has a UVLO feature to turn off the EV kit operation
during low input supply voltage and an overvoltage
protection to protect the EV kit under an open-LED condition.
The MAX16802B EV kit is a fully assembled and
tested board.
Warning: Under severe fault or failure conditions, this
EV kit may dissipate large amounts of power, which
could result in the mechanical ejection of a component
or of component debris at high velocity. Operate this
EV kit with care to avoid possible personal injury.
Key Features- 10.8V to 30V Wide Supply Voltage Range
- Current-Controlled Output
- Up to 750mA LED Current at 12V Output
- Linear and PWM Dimming Control
- Over 80% Efficiency at Full Load
- Supply Undervoltage Lockout
- Output Overvoltage Protection
| Applications/Uses- Commercial and Industrial Lighting
- Decorative and Architectural Lighting
- Offline and DC-DC LED Drivers
- RGB Back Light for LCD TVs and Monitors
|
DataSheet
Ordering Information
| Part Number | Status | Recommended Replacement | Package |
|---|
| MAX16802BEVKIT | Active | | EVKIT; |
