TJA1020: LIN transceiver
The TJA1020 is the interface between the LIN master/slave protocol controller and the physical bus in a Local Interconnect Network (LIN). It is primarily intended for in-vehicle sub-networks using baud rates from 2.4 up to 20 Kbaud.
The transmit data stream of the protocol controller at the TXD input is converted by the LIN transceiver into a bus signal with controlled slew rate and wave shaping to minimize EME. The LIN bus output pin is pulled HIGH via an internal termination resistor. For a master application an external resistor in series with a diode should be connected between pin INH or pin BAT and pin LIN. The receiver detects the data stream at the LIN bus input pin and transfers it via pin RXD to the microcontroller.
In normal transceiver operation the TJA1020 can be switched in the normal slope mode or the low slope mode. In the low slope mode the TJA1020 lengthens the rise and fall slopes of the LIN bus signal, thus further reducing the already very low emission in normal slope mode.
In sleep mode the power consumption of the TJA1020 is very low, whereas in failure modes the power consumption is reduced to a minimum.
TJA1020: Product Block Diagram
sot096-1_3d
General
- Baud rate up to 20 Kbaud
- Very low ElectroMagnetic Emission (EME)
- High ElectroMagnetic Immunity (EMI)
- Low slope mode for an even further reduction of EME
- Passive behaviour in unpowered state
- Input levels compatible with 3.3 and 5 V devices
- Integrated termination resistor for Local Interconnect Network (LIN) slave applications
- Wake-up source recognition (local or remote)
- Supports K-line like functions.
Low power management
- Very low current consumption in sleep mode with local and remote wake-up.
Protections
- Transmit data (TXD) dominant time-out function
- Bus terminal and battery pin protected against transients in the automotive environment (ISO7637)
- Bus terminal short-circuit proof to battery and ground
- Thermally protected.
Data Sheets (1)
| Name/Description | Modified Date |
|---|---|
| LIN transceiver (REV 5.0) PDF (129.0 kB) TJA1020 | 13 Jan 2004 |
Application Notes (2)
| Name/Description | Modified Date |
|---|---|
| TJA1020 LIN Transceiver (REV 2.0) PDF (949.0 kB) AN00093 | 29 Apr 2005 |
| Philips Microcontrollers in LIN Applications (REV 1.0) PDF (1.5 MB) AN10115 | 15 Feb 2002 |
Package Information (1)
| Name/Description | Modified Date |
|---|---|
| plastic small outline package; 8 leads; body width 3.9 mm (REV 1.0) PDF (244.0 kB) SOT96-1 | 08 Feb 2016 |
Packing (2)
| Name/Description | Modified Date |
|---|---|
| SO8; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending, 518 or Y Ordering... (REV 1.0) PDF (128.0 kB) SOT96-1_518 | 02 Jun 2014 |
| SO8; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending ,118 or J Ordering... (REV 2.0) PDF (232.0 kB) SOT96-1_118 | 19 Apr 2013 |
Supporting Information (3)
| Name/Description | Modified Date |
|---|---|
| Wave Soldering Profile (REV 1.0) PDF (20.0 kB) WAVE_SOLDERING_PROFILE | 30 Sep 2013 |
| Footprint for reflow soldering (REV 1.0) PDF (9.0 kB) SO-SOJ-REFLOW | 08 Oct 2009 |
| Footprint for wave soldering (REV 1.0) PDF (8.0 kB) SO-SOJ-WAVE | 08 Oct 2009 |
Design Support
- Simulation model request form: TJA1020 (REV 1.0) DOC TJA1020_1_2 1/4/2011
Ordering Information
| Product | Category | Product category | Supported standards | Package name | Package version | Low power modes | Supply voltage [min] (V) | Supply voltage [max] (V) | Data rate [min] (kb/s) | Data rate [max] (kb/s) | CAN channels | LIN channels | FlexRay Channels | Voltage on bus pins [min] (V) | Voltage on bus pins [max] (V) | VESD HBM on bus pins (+/- kV) | VIO option available | Tvj [max] (°C) | Rth(j-a) (K/W) | Under-voltage detection | TX Dominant Time out | Over-temperature detection | INH / Wake Pin | Min High Input Levels (V) | No of pins | Application | Recommended Version |
|---|
Package Information
| Product ID | Package Description | Outline Version | Reflow/Wave Soldering | Packing | Product Status | Part NumberOrdering code(12NC) | Marking | Chemical Content | RoHS / Pb Free / RHF | LeadFree Conversion Date | MSL | MSL LF |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| TJA1020T/CM | | SOT96-1 | SO-SOJ-REFLOW
SO-SOJ-WAVE SO-SOJ-REFLOW SO-SOJ-WAVE | Reel 13" Q1/T1 | Active | TJA1020T/CM,118 (9352 950 78118) | Standard Marking | TJA1020T/CM |    | Always Pb-free | 1 | 1 |
| TJA1020T/N1 | | SOT96-1 | SO-SOJ-REFLOW
SO-SOJ-WAVE SO-SOJ-REFLOW SO-SOJ-WAVE | Reel 13" Q1/T1 | Discontinued | TJA1020T/N1,118 (9352 687 33118) | Standard Marking | TJA1020T/N1 |  | week 3, 2005 | 1 | 1 |
| Bulk Pack | Discontinued | TJA1020T/N1,112 (9352 687 33112) | Standard Marking | TJA1020T/N1 | | week 3, 2005 | 1 | 1 | ||||
| TJA1020T/VM | | SOT96-1 | SO-SOJ-REFLOW
SO-SOJ-WAVE SO-SOJ-REFLOW SO-SOJ-WAVE | Bulk Pack | Discontinued | TJA1020T/VM,112 (9352 866 89112) | Standard Marking | TJA1020T/VM | | Always Pb-free | 1 | 1 |
| Reel 13" Q1/T1 | Discontinued | TJA1020T/VM,118 (9352 866 89118) | Standard Marking | TJA1020T/VM | | Always Pb-free | 1 | 1 |
- LIN transceiver TJA1020
- TJA1020 LIN Transceiver pesd1lin
- Philips Microcontrollers in LIN Applications TJA1020
- SO8; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending, 518 or Y Ordering... TJA1020
- Reflow_Soldering_Profile Wave_Soldering_Profile LPC1112FD20
- Simulation model request form: TJA1020 TJA1020T
- plastic small outline package; 8 leads; body width 3.9 mm CBT3306_Q100
- Footprint for reflow soldering NPIC6C596A_Q100
- Footprint for wave soldering NPIC6C596A_Q100
- SO8; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending ,118 or J Ordering... CBT3306_Q100
- TJA1020
- SA612A
