PCA9535A: Low-voltage 16-bit I²C-bus I/O port with interrupt

The PCA9535A is a low-voltage 16-bit General Purpose Input/Output (GPIO) expander with interrupt and reset for I²C-bus/SMBus applications. NXP I/O expanders provide a simple solution when additional I/Os are needed while keeping interconnections to a minimum, for example, in ACPI power switches, sensors, push buttons, LEDs, fan control, etc.

In addition to providing a flexible set of GPIOs, the wide VDD range of 1.65 V to 5.5 V allows the PCA9535A to interface with next-generation microprocessors and microcontrollers where supply levels are dropping down to conserve power.

The PCA9535A contains the PCA9535 register set of four pairs of 8-bit Configuration, Input, Output, and Polarity Inversion registers.

The PCA9535A is a pin-to-pin replacement to the PCA9535 and other industry-standard devices. A more fully featured device, the PCAL9535A, is available with Agile I/O features. See the respective data sheet for more details.

The PCA9535A open-drain interrupt (INT) output is activated when any input state differs from its corresponding Input Port register state and is used to indicate to the system master that an input state has changed.

INT can be connected to the interrupt input of a microcontroller. By sending an interrupt signal on this line, the remote I/O can inform the microcontroller if there is incoming data on its ports without having to communicate via the I²C-bus. Thus, the PCA9535A can remain a simple slave device.

The device outputs have 25 mA sink capabilities for directly driving LEDs while consuming low device current.

The power-on reset sets the registers to their default values and initializes the device state machine.

Three hardware pins (A0, A1, A2) select the fixed I²C-bus address and allow up to eight devices to share the same I²C-bus/SMBus.

Outline 3d SOT355-1

Data Sheets (1)

Name/Description	Modified Date
Low-voltage 16-bit I2C-bus I/O port with interrupt (REV 1.1) PDF (2.4 MB) PCA9535A	29 May 2015

Application Notes (1)

Name/Description	Modified Date
Low Voltage Agile I/O GPIO Input/Output Characteristics (REV 1.0) PDF (443.0 kB) AN11496	15 Aug 2014

Package Information (2)

Name/Description	Modified Date
plastic thin shrink small outline package; 24 leads; body width 4.4 mm (REV 1.0) PDF (353.0 kB) SOT355-1	08 Feb 2016
plastic thermal enhanced very very thin quad flat package; no leads; 24 terminals; body 4 x 4 x 0.75 mm (REV 1.0) PDF (213.0 kB) SOT994-1	08 Feb 2016

Packing (2)

Name/Description	Modified Date
HWQFN24; Reel pack, SMD, 13" Q2/T3 standard product orientation Orderable part number ending ,128 or... (REV 1.1) PDF (190.0 kB) SOT994-1_128	15 Jul 2016
TSSOP24; Reel pack; SMD, 13" Q1/T1 Standard product orientation Orderable part number ending ,118 or... (REV 4.1) PDF (227.0 kB) SOT355-1_118	15 Apr 2013

Supporting Information (1)

Name/Description	Modified Date
Footprint for wave soldering (REV 1.0) PDF (16.0 kB) SSOP-TSSOP-VSO-WAVE	08 Oct 2009

Design Support

Expert mode sample code for 16-bit Totem Pole (REV 1.0) TXT 16-BIT-TOTEM-POLE-READ-WRITE 12/10/2014

Ordering Information

Product	Status
PCA9535APW	Active
PCA9535AHF	Active

Package Information

Product ID	Package Description	Outline Version	Reflow/Wave Soldering	Packing	Product Status	Part NumberOrdering code(12NC)	Marking	Chemical Content	RoHS / Pb Free / RHF	LeadFree Conversion Date	EFR	IFR(FIT)	MTBF(hour)	MSL	MSL LF
PCA9535APW		SOT355-1	SSOP-TSSOP-VSO-WAVE	Reel 13" Q1/T1	Active	PCA9535APW,118 (9352 980 95118)	PCA9535A	PCA9535APW		Always Pb-free	0.0	4.0	2.5E8	1	1
PCA9535AHF		SOT994-1		Reel 13" Q2/T3	Active	PCA9535AHF,128 (9352 980 93128)	535A	PCA9535AHF		Always Pb-free	0.0	4.0	2.5E8	1	1