SAA7706H: Car radio Digital Signal Processor (DSP)
The SAA7706H performs all the signal functions in front of the power amplifiers and behind the car radio tuner AM and FM outputs and the CD, tape and phone inputs. These functions are:
Some functions have been implemented in hardware (FM stereo decoder, RDS-demodulator and FM Interference Absorption Circuit (IAC) and are not freely programmable.
Digital audio signals from external sources with the Philips I²S-bus and the LSB-justified 16, 18, 20 and 24 bits format or SPDIF format are accepted.
The big advantage of this SAA7706H device is the ?dual media support?; this enables independent front seat and rear seat audio sources and control.
SAA7706H: Product Block Diagram
sot318-2_3d
Hardware
- 5-bitstream 3rd-order sigma-delta Analog-to-Digital Converters (ADCs) with anti-aliasing broadband input filter
- 1-bitstream 1st-order sigma-delta ADC with anti-aliasing broadband input filter
- 4-bitstream Digital-to-Analog Converters (DACs) with 128-fold oversampling and noise shaping
- Integrated semi-digital filter; no external post filter required for DAC
- Dual media support: allowing separate front-seat and rear-seat signal sources and separate control
- Simultaneous radio and audio processing
- Digital FM stereo decoder
- Digital FM interference suppression
- RDS demodulation via separate ADC; with buffered output option
- Two mono Common-Mode Rejection Ratio (CMRR) input stages for voice signals from phone and navigation inputs
- Phone and navigation mixing at DAC front outputs
- Two stereo CMRR input stages (CD-walkman and CD-changer etc.)
- Analog single-ended TAPE and AUX input
- Separate AM-left and AM-right inputs in the event of use of external AM stereo decoder
- One digital input: I²S-bus or LSB-justified format
- Two digital inputs: SPDIF format
- Co-DSP support via I²S-bus or LSB-justified format
- Audio output short-circuit protected
- I²C-bus controlled (including fast mode)
- MOST bus interfacing (details in separate manual)
- Phase-locked loop derives the internal clocks from one common fundamental crystal oscillator
- Combined AM/FM level input
- Pin compatible with SAA7705 and SAA7708
- All digital inputs are tolerant of 5 V input levels
- All analog inputs have high GSM immunity
- Low number of external components required
- -40 to +85 Cel operating temperature range
- Easy applicable.
Software
- Improved FM weak signal processing
- Integrated 19 kHz MPX filter; de-emphasis and stereo detection
- Electronic adjustments: FM or AM level, FM channel separation, Dolby 1) level
- Baseband audio processing (treble, bass, balance, fader and volume)
- Four channel 5-band parametric equalizer
- 9-bands mono audio spectrum analyzer
- Extended beep functions with tone sequencer for phone rings
- Large volume jumps e-power interpolated to prevent zipper noise
- Dual media support; allowing separate front-seat and rear-seat signal sources and separate control
- Dynamic loudness or bass boost
- Audio level monitor
- Tape equalization and Music Search System (MSS) detection for tape
- Dolby-B tape noise reduction (at 44.1 kHz only)
- Dynamics compression available in all modes
- CD de-emphasis processing
- Voice-over possibility for phone and navigation signals
- Improved AM signal processing
- Digital AM CQUAM stereo decoder (not in all rom_codes available)
- Digital AM interference suppression
- Soft audio mute
- RDS update processing: pause detection, mute and signal-quality sensor-freeze
- General purpose tone generator
- Noise generator allows for frequency response measurements
- Boot-up ROM for fast start-up
- Signal level, noise and multipath detection for AM or FM signal quality information
- AM co-channel and adjacent channel detection (not in all rom_codes available).
1) Dolby - Available only to licensees of Dolby Laboratories Licensing Corporation, San Francisco, CA94111, USA, from whom licensing and application information must be obtained. Dolby is a registered trade-mark of Dolby Laboratories Licensing Corporation.
Data Sheets (1)
Application Notes (1)
Package Information (1)
Supporting Information (1)
Ordering Information
| Product | Status | Status | Budgetary Price excluding tax(US$) | Package Type and Termination Count | GPIOs | Qualification Tier |
|---|
| SAA7706H/N210S | No Longer Manufactured | | | | | |
| SAA7706H/N210 | No Longer Manufactured | | | | | |
| SAA7706H/N108 | No Longer Manufactured | | | | | |
| SAA7706H/N107S | No Longer Manufactured | | | | | |
| SAA7706H/N109S | No Longer Manufactured | | | | | |
| SAA7706H/N106 | No Longer Manufactured | | | | | |
| SAA7706H/N107 | No Longer Manufactured | | | | | |
| SAA7706H/N109 | No Longer Manufactured | | | | | |
| SAA7706H/N108Y | No Longer Manufactured | | | | | |
Package Information
| Product ID | Package Description | Outline Version | Reflow/Wave Soldering | Packing | Product Status | Part NumberOrdering code(12NC) | Marking | Chemical Content | RoHS / Pb Free / RHF | LeadFree Conversion Date | MSL | MSL LF |
|---|
| SAA7706H/N109S | | SOT318-2 | QFP-SQFP-TQFP-WAVE | Tray, Bakeable, Multiple in Drypack | Withdrawn | SAA7706H/N109S,557
(9352 889 99557) | Standard Marking | |    | Always Pb-free | 3 | 3 |
| SAA7706H/N210 | | SOT318-2 | QFP-SQFP-TQFP-WAVE | Tray, Bakeable, Multiple in Drypack | Withdrawn | SAA7706H/N210,557
(9352 702 85557) | Standard Marking | |  | week 12, 2005 | 3 | 3 |
| SAA7706H/N210S | | SOT318-2 | QFP-SQFP-TQFP-WAVE | Reel 13" Q1/T1 in Drypack | Withdrawn | SAA7706H/N210S,518
(9352 890 01518) | Standard Marking | | | Always Pb-free | 3 | 3 |
