STBCFG01:Switch-mode Single Cell Li+ Battery Charger with OTG Boost, Voltage Mode Fuel Gauge and LDO

The STBCFG01 is a switching battery charger integrating the functions needed to charge single cell Li-Ion batteries, monitor the battery charge state and generate 5 V to supply USB OTG bus powered devices.

The IC also integrates an LDO regulator to support system boot in dead battery conditions.

The battery charger features a smart input current limit: the maximum input current can be selected through I2C and if the input voltage drops below a programmable threshold the input current is reduced even if the selected maximum current limit has not been reached yet. The dynamic input current limit can be disabled.

An automatic input pre-bias load makes the device suitable for applications using voltage sources needing a minimum external load for proper regulation.

The STBCFG01 also integrates a voltage mode fuel gauge to provide accurate state of charge evaluation without the current sensing resistor.

Key Features

  • High efficiency switching battery charger
    • 2 MHz or 3 MHz switching frequency
    • 1.2 A max. charging current
    • 20 V tolerant input with OVP
    • Programmable input current limitation and dynamic input current limit
    • Battery overvoltage protection
    • Auto-recharge
    • Integrated current sensing resistor
    • USB compatible
  • Voltage mode fuel gauge
    • No need for external sensing resistor
    • Battery swap detection through ID resistor
    • Low battery voltage and low SOC programmable alarms
  • 50 mA LDO for system boot in dead battery condition
  • USB OTG VBUS generation (500 mA)
    • USB overvoltage protection
    • Programmable battery overcurrent protection
  • Automatic 60 mA input pre-bias
  • I2 C compatible control interface
  • Interrupt output pin
  • Flip chip package, 25 bumps
Product Specifications
DescriptionVersionSize
DS10380: Switch mode single cell Li+ battery charger with OTG boost, voltage mode fuel gauge and LDO3.01 MB
DB2151: Switch-mode single Cell Li+ battery charger with OTG boost, voltage mode fuel gauge and LDO1.0234 KB
Selection Guides
DescriptionVersionSize
Linear and Switching Voltage Regulators Selection Guide383 KB
Brochures
DescriptionVersionSize
Brochure Power management guide05.20164 MB
Solution Evaluation Tools
Part NumberManufacturerDescription
STEVAL-ISB033V1STEvaluation board for STBCFG01 single-cell Li+ battery charger with OTG boost, voltage mode fuel gauge and 200 mA LDO
Sample & Buy
Part NumberPackagePacking TypeUnit Price (US$) *QuantityECCN (EU)ECCN (US)Country of Origin
STBCFG01JRChip Scale Package 0.4mm pitchTape And Reel--NECEAR99-
Quality & Reliability
Part NumberPackageGradeRoHS Compliance GradeMaterial Declaration**
STBCFG01JRChip Scale Package 0.4mm pitchIndustrialEcopack2
Switch mode single cell Li+ battery charger with OTG boost, voltage mode fuel gauge and LDO STBCFG01
DB2151: Switch-mode single Cell Li+ battery charger with OTG boost, voltage mode fuel gauge and LDO STBCFG01
Switch-mode single Cell Li+ battery charger with OTG boost, voltage mode fuel gauge and LDO STBCFG01
Digital controller for wireless battery charger transmitters for wearable and smartwatch applications STWBC-WA
Very low drop voltage regulators with inhibit KFXX