• 简体中文
• English

MAX367：信号通道电路保护器、三个独立的保护器

The MAX366 and MAX367 are multiple, two-terminal circuit protectors. Placed in series with signal lines, each two-terminal device guards sensitive circuit components against voltages near and beyond the normal supply voltages. These devices are used at interfaces where sensitive circuits are connected to the external world and could encounter damaging voltages (up to 35V beyond the supply rails) during power-up, power-down, or fault conditions. The MAX366 contains three independent protectors and the MAX367 contains eight. They can protect analog signals using either unipolar (4.5V to 36V) or bipolar (±2.25V to ±18V) power supplies. Each protector is symmetrical. Input and output terminals may be freely interchanged. These devices are voltage-sensitive MOSFET transistor arrays that are normally on when power is applied and normally open circuit when power is off. With ±10V supplies, on-resistance is 100Ω max and leakage is less than 1nA at +25°C. When signal voltages exceed or are within approximately 1.5V of either power-supply voltage (including when power is off), the two-terminal resistance increases dramatically, limiting fault current as well as output voltage to sensitive circuits. The protected side of the switch maintains the correct polarity and clamps approximately 1.5V below the supply rail. There are no "glitches" or polarity reversals going into or coming out of a fault condition.

关键特性 ±40V Overvoltage Protection Open Signal Paths with Power Off 100Ω Signal Paths with Power On 1nA Max Path Leakage at +25°C 44V Maximum Supply Voltage Rating Automatic Protection; No Programming or Controls

MAX366、MAX367：典型工作电路 应用 自动测试设备(ATE) 数据采集 热插拔板/系统 过程控制系统 冗余/备份系统 高灵敏度仪表

数据手册DataSheet

关键参数

技术资料

• Automatic Test Equipment on a Budget

质量和环境数据

• MAX367.pdf

订购型号