• 简体中文
• English

CLRC66301HN：High performance NFC reader solution

The CLRC663 is a highly integrated transceiver IC for contactless communication at 13.56 MHz.

The CLRC663 transceiver IC supports the following operating modes:

The CLRC663’s internal transmitter is able to drive a reader/writer antenna designed to communicate with ISO/IEC 14443A/MIFARE cards and transponders without additional active circuitry. The digital module manages the complete ISO/IEC 14443A framing and error detection functionality (parity and CRC).

The CLRC663 supports MIFARE Classic 1K, MIFARE Classic 4K, MIFARE Ultralight, MIFARE Ultralight C, MIFARE PLUS and MIFARE DESFire products. The CLRC663 supports MIFARE higher transfer speeds of up to 848 kbit/s in both directions.

The CLRC663 supports layer 2 and 3 of the ISO/IEC 14443B reader/writer communication scheme except anticollision. The anticollision needs to be implemented in the firmware of the host controller as well as in the upper layers.

The CLRC663 is able to demodulate and decode FeliCa coded signals.The FeliCa receiver part provides the demodulation and decoding circuitry for FeliCa coded signals. The CLRC663 handles the FeliCa framing and error detection such as CRC. The CLRC663 supports FeliCa higher transfer speeds of up to 424 kbit/s in both directions.

The CLRC663 is supporting the P2P passive initiator mode in accordance with ISO/IEC 18092.

The CLRC663 supports the vicinity protocol according to ISO/IEC15693, EPC UID and ISO/IEC 18000-3 mode 3/ EPC Class-1 HF.

The following host interfaces are supported:

The CLRC663 supports the connection of a secure access module (SAM). A dedicated separate I2C interface is implemented for a connection of the SAM. The SAM can be used for high secure key storage and acts as a very performant crypto coprocessor. A dedicated SAM is available for connection to the CLRC663.

特性和优势 Includes NXP ISO/IEC14443-A, Innovatron ISO/IEC14443-B and NXP MIFARE Crypto 1 intellectual property licensing rights Fast and cost-efficient NFC design startup High performance multi-protocol NFC frontend for transfer speed up to 848 kbit/s Supports ISO/IEC 14443 A/MIFARE, ISO/IEC 14443 B and FeliCa P2P passive initiator mode in accordance with ISO/IEC 18092 Supports ISO/IEC15693, ICODE EPC UID and ISO/IEC 18000-3 mode 3/ EPC Class-1 HF Supports MIFARE Classic encryption in read/write mode Low-Power Card Detection Compliance to “EMV contactless protocol specification V2.3.1” on RF level can be achieved Antenna connection with minimum number of external components Supported host interfaces: SPI up to 10 Mbit/s I²C-bus interfaces up to 400 kBd in Fast mode, up to 1000 kBd in Fast mode plus RS232 Serial UART up to 1228.8 kBd, with voltage levels dependent on pin voltage supply SPI up to 10 Mbit/s I²C-bus interfaces up to 400 kBd in Fast mode, up to 1000 kBd in Fast mode plus RS232 Serial UART up to 1228.8 kBd, with voltage levels dependent on pin voltage supply Separate I²C-bus interface for connection of a secure access module (SAM) FIFO buffer with size of 512 byte for highest transaction performance Flexible and efficient power saving modes including hard power down, standby and low-power card detection Cost saving by integrated PLL to derive system CPU clock from 27.12 MHz RF quartz crystal 3 V to 5.5 V power supply Up to 8 free programmable input/output pins Typical operating distance in read/write mode for communication to a ISO/IEC 14443A/MIFARE Card up to 12 cm, depending on the antenna size and tuning

产品图片

关键参数

封装与包装

型号	封装	Outline version	Reflow-/Wave soldering	包装	产品状态	标示	可订购的器件编号, (订购码 (12NC))
CLRC66301HN	HVQFN32 (SOT617-1)	sot617-1_po	sot617-1_fr	Tray, Bakeable, Multiple in Drypack	量产	Standard Marking	CLRC66301HN,557( 9352 934 46557 )
				Tray, Bakeable, Single in Drypack	量产	Standard Marking	CLRC66301HN,551( 9352 934 46551 )

无铅环保信息

型号	可订购的器件编号	RoHS / RHF	无铅转换日期	潮湿敏感度等级	MSL LF
CLRC66301HN	CLRC66301HN,557		Always Pb-free	2	2
CLRC66301HN	CLRC66301HN,551		Always Pb-free	2	2

文档资料

订购信息

Software