工业级ATmega1284P-MU 带有128K系统内可编程Flash存储器QFN-44封装
Flash (Kbytes) |
128 |
EEPROM (Kbytes) |
4 |
SRAM (Bytes) |
16K |
Max I/O Pins |
32 |
F.max (MHz) |
20 |
Vcc (V) |
1.8 - 5.5 |
10-bit A/D Channels |
Yes |
Analog Comparator |
Yes |
16-bit Timers |
2 |
8-bit Timer |
2 |
Brown Out Detector |
Yes |
Ext Interrupts |
3 |
Hardware Multiplier |
Yes |
Interrupts |
35 |
ISP |
Yes |
On Chip Oscillator |
Yes |
PWM Channels |
6 |
RTC |
Yes |
Self Program Memory |
Yes |
SPI |
Yes |
TWI |
Yes |
UART |
2 |
Watchdog |
Yes |
Pb-Free Packages |
MLF (VQFN) 44
PDIP 40 TQFP 44 |
128K Bytes self-programming Flash Program Memory, 16K Bytes SRAM, 4K Bytes EEPROM, two 16-bit Timer/Counters, two 8-bit Timer/Counters, Real Time Counter, 8 Channel 10-bit A/D-converter(TQFP/MLF). JTAG Interface for On-chip Debug. Up to 20 MIPS throughput at 20 MHz. The ATmega1284P is a low-power CMOS 8-bit microcontroller based on the AVR enhanced
RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega1284P
achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize
power consumption versus processing speed.
ATmega1284P-MU 产品特性
- High-performance, Low-power AVR® 8-bit Microcontroller
- Advanced RISC Architecture
– 131 Powerful Instructions – Most Single-clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
– Up to 20 MIPS Throughput at 20 MHz
– On-chip 2-cycle Multiplier
- Nonvolatile Program and Data Memories
– 128K Bytes of In-System Self-Programmable Flash
Endurance: 10,000 Write/Erase Cycles
– Optional Boot Code Section with Independent Lock Bits
In-System Programming by On-chip Boot Program
True Read-While-Write Operation
– 4K Bytes EEPROM
Endurance: 100,000 Write/Erase Cycles
– 16K Bytes Internal SRAM
– Programming Lock for Software Security
- JTAG (IEEE std. 1149.1 Compliant) Interface
– Boundary-scan Capabilities According to the JTAG Standard
– Extensive On-chip Debug Support
– Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface
- Peripheral Features
– Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
– Two 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture
Mode
– Real Time Counter with Separate Oscillator
– Six PWM Channels
– 8-channel, 10-bit ADC
Differential mode with selectable gain at 1x, 10x or 200x
– Byte-oriented Two-wire Serial Interface
– Two Programmable Serial USART
– Master/Slave SPI Serial Interface
– Programmable Watchdog Timer with Separate On-chip Oscillator
– On-chip Analog Comparator
– Interrupt and Wake-up on Pin Change
- Special Microcontroller Features
– Power-on Reset and Programmable Brown-out Detection
– Internal Calibrated RC Oscillator
– External and Internal Interrupt Sources
– Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby
and Extended Standby
- I/O and Packages
– 32 Programmable I/O Lines
– 40-pin PDIP, 44-lead TQFP, and 44-pad QFN/MLF
- Operating Voltages
– 1.8 - 5.5V for ATmega1284P
- Speed Grades
– 0 - 4 MHz @ 1.8 - 5.5V
– 0 - 10 MHz @ 2.7 - 5.5V
– 0 - 20 MHz @ 4.5 - 5.5V
- Power Consumption at 1 MHz, 1.8V, 25°C
– Active: TBD μA
– Power-down Mode: TBD μA
– Power-save Mode: TBD μA (Including 32 kHz RTC)
8-bit
Microcontroller
with 128K Bytes
In-System
Programmable
Flash
ATmega1284P
Preliminary
8059B–AVR–05/08
ATmega1284P-MU 订购型号
ATmega1284P-MU 应用技术支持与电子电路设计开发资源下载
- ATMEL 爱特梅尔AVR 微控制器ATmega1284P 数据手册DataSheet 下载. PDF(简洁版)
- ATMEL 爱特梅尔AVR 微控制器ATmega1284P 数据手册DataSheet 下载. PDF(完整版)
- Atmel 爱特梅尔AVR 微控制器简介.PDF (编号:Tech AVR 000)MLF 32
- 面向新手的AVR 开发工具,及基本知识.PDF(编号:Tech AVR 001)
- 使用AVR 定时/计数器的PWM功能设计要点 .PDF
- AVR指令集(版本:0856G–AVR–07/08)
- AVR 微控制器汽车应用解决方案 . pdf
- AVR 微控制器选型指南. pdf
- ATMEL 爱特梅尔公司全线产品目录. pdf