IP175G 5-port 10/100M Ethernet Integrated Switch
IP175G is fabricated with advanced CMOS(85nm/Low Power) technology and only requires a 3.3V sinlge power supply. This feature makes IP175G consumes very low power, such as the full load operation (100Mbps_FDX x8) and embedded LDO, overall power consumption only takes 0.55w.
IP175G also supports Power Management Tool (PWMT® ) for IEEE 802.3az, APS, WOL+ and PWD for Green Power. While two link devices have no IEEE 802.3az capability, IP175G use WOL+ to change link from 100Mbps to 10Mbps for saving power.
The PWD of IP175G is designed for power down switch immediately by pushing a botton, user don’t plug out the power adapter. Push the button again, it will power on immediately.
Except Low Power and Rich Power Saving method, IP175G supports AFT® for saving Customer Testing Cost. By using a push bottom and cables, IP175G will Auto test completely by itself
特性
-
5 port Embedded 10/100 PHY Switch Controller
-
Support 5 100BaseTX or 4 100Base TX + 1 FX
-
Support Auto MDI-MDIX function
- Power Management Tool (PWMT®)
- APS, auto-power saving while Link-off
- IEEE 802.3az protocol based power saving & 10Mbps Te for 10Mbps
- WOL+®, light traffic power saving
- PWD, force-off power saving
-
Support Auto Factory Test (AFT®)
-
Single Power 3.3V supply
-
Built in Vcore Regulator
-
Two Priority queues per port
- Support 802.1p & DiffServ based QoS
- QoS - Port base
- 802.1p
- IP DiffServ IPV4/IPV6- TCP/UDP port number- Pins configure ports priority (VIP port)
-
Support max forwarding packet length 1552/1536 bytes option
-
Support port mirror function
-
Support 1k MAC address
-
Support broadcast storm protection
-
Support port trunking (LACP)
- Support 16 VLAN (IEEE Std 802.1q)- Port-based/Tagged-based VLAN- Support insert, remove tag
-
Built-in 50 ohm resistors for simplifying BOM
-
85nm Process
-
Package and operation temperature
- IP175G: 48 Pin QFN(6x6), 0~70℃
IP175G 技术资料
