MC10EP89: Coaxial Cable Driver
The MC10EP89 is a differential fanout gate specifically designed to drive coaxial cables. The device is especially useful in digital video broadcasting applications; for this application, since the system is polarity free, each output can be used as an independent driver. The driver produces swings 70% larger than a standard ECL output. When driving a coaxial cable, proper termination is required at both ends of the line to minimize signal loss. The 1.6 V (5 V) and 1.4 V (3.3 V) swing allow for termination at both ends of the cable, while maintaining a 800 mV (5 V) and 700 mV (3.3 V) swing at the receiving end of the cable. Because of the larger output swings, the device cannot be terminated into the standard VCC-2.0 V. All of the DC parameters are tested with a 50 ohms to VCC-3.0 V load. The driver accepts a standard differential ECL input and can run off of the digital video broadcast standard -5.0 V supply.
特性
- 310ps Typical Propagation Delay
- Maximum Frequency > 2 Ghz Typical
- 1.6V (5V) and 1.4V (3.3V) VOUTpp Swing
- PECL Mode Operating Range: VCC= 3.0 V to 5.5 V with VEE= 0 V
- NECL Mode Operating Range: VCC= 0 V with VEE= -3.0 V to -5.5 V
- Open Input Default State
- Safety Clamp on Inputs
- Q Output will default LOW with inputs open or at VEE
- Pb-Free Packages are Available
|
封装图 PACKAGE DIMENSIONS
|
订购信息 Ordering Information
| 产品 |
状况 |
Compliance |
具体说明 |
封装 |
MSL* |
容器 |
预算价格 (1千个数量的单价） |
| 类型 |
外形 |
类型 |
数量 |
| MC10EP89DG |
Active |
|
Coaxial Cable Driver |
SOIC-8 |
751-07 |
1 |
Tube |
98 |
|
| MC10EP89DR2G |
Active |
|
Coaxial Cable Driver |
SOIC-8 |
751-07 |
1 |
Tape and Reel |
2500 |
|
| MC10EP89DTG |
Active |
|
Coaxial Cable Driver |
TSSOP-8 |
948R-02 |
3 |
Tube |
100 |
|
| MC10EP89DTR2G |
Active |
|
Coaxial Cable Driver |
TSSOP-8 |
948R-02 |
3 |
Tape and Reel |
2500 |
|
| MC10EP89MNR4G |
Active |
|
Coaxial Cable Driver |
DFN-8 |
506AA |
1 |
Tape and Reel |
1000 |
|
数据资料DataSheet下载
