STTS751 2.25 V low-voltage local digital temperature sensor
The STTS751 is a digital temperature sensor which communicates over a 2-wire SMBus 2.0 compatible bus. The temperature is measured with a user-configurable resolution between 9 and 12 bits. At 9 bits, the smallest step size is 0.5 °C, and at 12 bits, it is 0.0625 °C. At the default resolution (10 bits, 0.25 °C/LSB), the conversion time is nominally 21 milliseconds.
The open-drain EVENToutput is used to indicate an alarm condition in which the measured temperature has exceeded the user-programmed high limit or fallen below the low limit. When the EVENTpin is asserted, the host can respond using the SMBus Alert Response Address (ARA) protocol to which the STTS751 will respond by sending its slave address.
The STTS751 is a 6-pin device that supports user-configurable slave addresses. Via the pull-up resistor on the Addr/Thermpin, one of four different slave addresses can be specified. Two order numbers (STTS751-0 and STTS751-1) provide two different sets of slave addresses bringing the total available to eight. Thus, up to eight devices can share the same 2-wire SMBus without ambiguity, thereby allowing monitoring of multiple temperature zones in an application.
The two-wire interface can support transfer rates up to 400 kHz. Two small footprint packages are available: a UDFN-6L and a standard SOT23-6L package
技术特性
- Operating voltage 2.25 V to 3.6 V
- Operating temperature –40 °C to +125 °C
- Programmable
- 10 different conversion rates 0.0625 to 32 conversions/sec. 1 conversion/sec. - default
- 4 different resolutions 9-bit (0.5 °C/LSB) to 12-bit (0.0625 °C/LSB) 10-bit (0.25 °C/LSB) - default
- Low supply current
- 50 μA (typ) for 8 conversions/sec.
- 20 μA (typ) for 1 conversion/sec.
- Accuracy
- ±1.0 °C (typ) 0 °C to +85 °C
- ±2.0 °C (typ) –40 °C to +125 °C
- One-shot mode for power saving
- Fast conversion time 21 ms (typ) 10-bit
- Pull-up resistor value allows single pin to select one of four slave addresses
- Supports 400 kHz serial clock
- SMBus 2.0 compatible
- SMBus ALERT (ARA) support
- RoHS/green
|
功能框图
 |
STTS751 订购信息
| 订购型号 |
产品状态 |
美金价格 |
数量 |
封装 |
包装形式 |
温度范围 |
材料声明 |
| STTS751-0WB3F |
Active |
|
1000 |
SOT23-6L |
Tape And Reel |
-40 °C-125 °C |
STTS751-0WB3F |
| STTS751-1WB3F |
Active |
|
1000 |
SOT23-6L |
Tape And Reel |
-40 °C-125 °C |
STTS751-1WB3F |
| STTS751-0DP3F |
Active |
|
1000 |
DFN6 2X2X0.5 |
Tape And Reel |
-40 °C-125 °C |
STTS751-0DP3F |
| STTS751-1DP3F |
Active |
|
1000 |
DFN6 2X2X0.5 |
Tape And Reel |
-40 °C-125 °C |
STTS751-1DP3F |
DATASHEET
| 描述 |
版本 |
大小 |
| STTS751 :2.25 V low-voltage local digital temperature sensor |
5 |
577KB |
USER MANUALS
| 描述 |
版本 |
大小 |
| UM1479: STEVAL-IPR002V1: M24LR64-R based data logger and event logger |
1 |
3484KB |
BOARDS AND TOOLS
| 型号 |
描述 |
| STEVAL-IFS017V3 |
Temperature sensor daughter card based on the STTS751-1DP3F in UDFN package |
| STEVAL-IFS017V2 |
Temperature sensor daughter card based on the STTS751-0DP3F in UDFN package |
| STEVAL-IFS017V4 |
Temperature sensor daughter card based on STTS751-0WB3F in SOT package |
| STEVAL-IFS017V5 |
Temperature sensor daughter card based on the STTS751-1WB3F in SOT package |
FLYERS
