
These octal bus transceivers are designed for asynchronous communication between data buses. The devices transmit data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control (DIR) input. The output-enable (OE)\ input can be used to disable the device so the buses are effectively isolated.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
This device is fully specified for hot-insertion applications using Ioff and power-up 3-state. The Ioff circuitry disables the outputs, preventing damaging current backflow through the device when it is powered down
| SN54ABT245A | |
| Voltage Nodes (V) | 5 |
| Rating | Military |
| Technology Family | ABT |
| 器件 | 状态 | 温度 | 价格(美元) | 封装 | 引脚 | 封装数量 | 封装载体 | 丝印标记 |
| 5962-9214802Q2A | ACTIVE | -55 to 125 | 10.35 | 1ku | LCCC (FK) | 20 | 1 | TUBE | |
| 5962-9214802QRA | ACTIVE | -55 to 125 | 6.47 | 1ku | CDIP (J) | 20 | 1 | TUBE | |
| 5962-9214802QSA | ACTIVE | -55 to 125 | 10.35 | 1ku | CFP (W) | 20 | 1 | TUBE | |
| SNJ54ABT245AFK | ACTIVE | -55 to 125 | 10.35 | 1ku | LCCC (FK) | 20 | 1 | TUBE | |
| SNJ54ABT245AJ | ACTIVE | -55 to 125 | 6.47 | 1ku | CDIP (J) | 20 | 1 | TUBE | |
| SNJ54ABT245AW | ACTIVE | -55 to 125 | 10.35 | 1ku | CFP (W) | 20 | 1 | TUBE |
| 器件 | 环保计划* | 铅/焊球涂层 | MSL 等级/回流焊峰 | 环保信息与无铅 (Pb-free) | DPPM / MTBF / FIT 率 |
| 5962-9214802Q2A | TBD | Call TI | Call TI | 5962-9214802Q2A | 5962-9214802Q2A |
| 5962-9214802QRA | TBD | Call TI | Call TI | 5962-9214802QRA | 5962-9214802QRA |
| 5962-9214802QSA | TBD | Call TI | Call TI | 5962-9214802QSA | 5962-9214802QSA |
| SNJ54ABT245AFK | TBD | POST-PLATE | N/A for Pkg Type | SNJ54ABT245AFK | SNJ54ABT245AFK |
| SNJ54ABT245AJ | TBD | A42 | N/A for Pkg Type | SNJ54ABT245AJ | SNJ54ABT245AJ |
| SNJ54ABT245AW | TBD | Call TI | N/A for Pkg Type | SNJ54ABT245AW | SNJ54ABT245AW |