EVAL-ADM1170EBZ:  1.6 V to 16.5 V Hot Swap Controller

The ADM1170 is a Hot Swap controller that allows a board to be safely inserted and removed from a live backplane. This is achieved using a pass FET with a current control loop that monitors the input current using a sense resistor. An internal charge pump is used to enhance the gate of the external high side N-channel FET. When an over current condition is detected the gate voltage of the FET is reduced to limit the current flowing through the sense resistor. The ADM1170 operates with a supply voltage ranging from 2.7V to 16.5V. Using separate SENSE pins from VCC the ADM1170 allows for the hotswap of supplies ranging down to 1.6V. During an overcurrent condition the timer cap determines the amount of time the FET will remain in this condition. The ON (ON/CLR) pin is the enable input for the device and also acts as a latched fault reset for the ADM1170-2 model. The SS pin is used to control the inrush current profile by ramping up the current sense limit at a rate set by the SS capacitor. This device is available in two options: the ADM1170-1 will automatic retry for over-current fault and the ADM1170-2 will latch-off for an over-current fault. The ADM1170 is packaged in an 8-lead TSOT package

产品应用领域 Applications
EVAL-ADM1170EBZ 特点
EVAL-ADM1170EBZ 功能框图

ADM1170 芯片订购指南
产品型号 产品状态 封装 引脚 温度范围
ADM1170-1AUJZ-RL7 量产 8 ld TSOT 8 工业
ADM1170-2AUJZ-RL7 量产 8 ld TSOT 8 工业
EVAL-ADM1170EBZ 量产 评估板 - 待定
EVAL-ADM1170EBZ 应用技术支持与电子电路设计开发资源下载
  1. ADM1170 数据手册DataSheet 下载 . pdf
  2. ADI 模拟器件公司比较器产品选型指南 . pdf
  3. Analog Devices, Inc. 美国模拟器件公司产品订购手册 .pdf
  4. 热插拨及电源监控器广告( pdf, 306kb)
  5. 电源监控器与时序控制器 . pdf