首页 > ATMEL 爱特梅尔 > ARM微控制器AT91

AT91SAM9263 32位ARM单片机

Status	Production
SRAM (Bytes)	96K
LCD Controller	1
Ethernet MAC 10/100	1
Image Sensor Interface	1
USB Host	2xFS
External Bus Interface	2
CAN	1
RTC/RTT	-/2
Peripheral DMA Channels	22
Max. Clock Speed (MHz)	240
I/O Pins	160
SDRAM Interface	2
NAND Flash ECC	1/1
Enhanced USART	3
USART/DBGU	-/1
SPI	2
TWI	1
SSC	2
MCI	2
USB Device	FS
PWM Controller	4
16-bit Timers	3
Period Interval Timer	1
Watchdog Timer	1
Power-On-Reset	2
Crystal Oscillator/PLL	2/2
ARM Core	926EJ-S
Cache Memory (Bytes)	2x16K
MMU/MPU	MMU
I/O Voltage Domain (V)	1.8/3.3
In-System Programming	Y
Single Supply	N
Pb-Free Packages	TFBGA 324

AT91SAM9263 描述

The AT91SAM9263 microcontroller-based system-on-chip embeds a 200 MIPS ARM926EJ-S-based processor. Its parallel bus architecture incorporating distributed DMA overcomes the bottlenecks that occur with conventional ARM9-based MCUs in graphically-interfaced, data-intensive applications such as networked medical monitoring equipment and GPS navigation systems. The AT91SAM9263 employs 27 DMA channels including Atmel抯 20-channel peripheral DMA controller (PDC), a 9-layer bus matrix, and two additional busses for data- and instruction-tightly-coupled-memories (TCMs) to boost CPU performance and provide on-chip data transfer rates of up to 41.6 Gbps. Two external bus interfaces (EBIs) support gigabyte-plus external memories.

On-chip human interface peripherals include a camera interface, TFT/STN LCD controller, a 6-channel audio front-end interface (AC97), I2S and a 2D graphics co-processor that off-loads line draw, block transfer, polygon fill, and clipping functions from the CPU. Networking peripherals include a 12 Mbps USB host and device, a 10/100 Ethernet MAC and a 1 Mbps control area network (CAN). There are also four USARTs, two 50 Mbps serial peripheral interfaces (SPI), CompactFlash, SDIO (MCI) and a two-wire interface (TWI) which can be connected to external wired and wireless communication modules like GPRS modem and Wi-Fi.

The AT91SAM9263 has two external bus interfaces (EBI): one for the system memory and one for the human interface. The second EBI eliminates the need for the LCD controller and CPU to share memory and can increase available CPU MIPS by 20% to 40%. The AT91SAM9263 is supported by the AT91SAM9263 Evaluation Board and extensive third-party application development tools. It supports both Linux and Windows CE. It has been developed for advanced system-on-chip applications such as GPS application processors that require both high computing performance and high data throughputs.

AT91SAM9263 特性

• Incorporates the ARM926EJ-S™ ARM® Thumb® Processor
  – DSP Instruction Extensions, Jazelle® Technology for Java® Acceleration
  – 16 Kbyte Data Cache, 16 Kbyte Instruction Cache, Write Buffer
  – 220 MIPS at 200 MHz
  – Memory Management Unit
  – EmbeddedICE™, Debug Communication Channel Support
  – Mid-level Implementation Embedded Trace Macrocell™
• Bus Matrix
  – Nine 32-bit-layer Matrix, Allowing a Total of 28.8 Gbps of On-chip Bus Bandwidth
  – Boot Mode Select Option, Remap Command
• Embedded Memories
  – One 128 Kbyte Internal ROM, Single-cycle Access at Maximum Bus Matrix Speed
  – One 80 Kbyte Internal SRAM, Single-cycle Access at Maximum Processor or Bus
  Matrix Speed
  – One 16 Kbyte Internal SRAM, Single-cycle Access at Maximum Bus Matrix Speed
• Dual External Bus Interface (EBI0 and EBI1)
  – EBI0 Supports SDRAM, Static Memory, ECC-enabled NAND Flash and
  CompactFlash®
  – EBI1 Supports SDRAM, Static Memory and ECC-enabled NAND Flash
• DMA Controller (DMAC)
  – Acts as one Bus Matrix Master
  – Embeds 2 Unidirectional Channels with Programmable Priority, Address
  Generation, Channel Buffering and Control
• Twenty Peripheral DMA Controller Channels (PDC)
• LCD Controller
  – Supports Passive or Active Displays
  – Up to 24 bits per Pixel in TFT Mode, Up to 16 bits per Pixel in STN Color Mode
  – Up to 16M Colors in TFT Mode, Resolution Up to 2048x2048, Supports Virtual
  Screen Buffers
• 2D Graphics Accelerator
  – Line Draw, Block Transfer, Polygon Fill, Clipping, Commands Queuing
• Image Sensor Interface
  – ITU-R BT. 601/656 External Interface, Programmable Frame Capture Rate
  – 12-bit Data Interface for Support of High Sensibility Sensors
  – SAV and EAV Synchronization, Preview Path with Scaler, YCbCr Format
• USB 2.0 Full Speed (12 Mbits per second) Host Double Port
  – Dual On-chip Transceivers
  – Integrated FIFOs and Dedicated DMA Channels
• USB 2.0 Full Speed (12 Mbits per second) Device Port
  – On-chip Transceiver, 2,432-byte Configurable Integrated DPRAM
• Ethernet MAC 10/100 Base-T
  – Media Independent Interface or Reduced Media Independent Interface
  – 28-byte FIFOs and Dedicated DMA Channels for Receive and Transmit
• Fully-featured System Controller, including
  – Reset Controller, Shutdown Controller
  – Twenty 32-bit Battery Backup Registers for a Total of 80 Bytes
  – Clock Generator and Power Management Controller
  – Advanced Interrupt Controller and Debug Unit
  – Periodic Interval Timer, Watchdog Timer and Double Real-time Timer
• Reset Controller (RSTC)
  Based on Two Power-on Reset Cells, Reset Source Identification and Reset Output Control
• Shutdown Controller (SHDWC)
  Programmable Shutdown Pin Control and Wake-up Circuitry
• Clock Generator (CKGR)
  32768Hz Low-power Oscillator on Battery Backup Power Supply, Providing a Permanent Slow Clock
  3 to 20 MHz On-chip Oscillator and Two Up to 240 MHz PLLs
• Power Management Controller (PMC)
  Very Slow Clock Operating Mode, Software Programmable Power Optimization Capabilities
  Four Programmable External Clock Signals
• Advanced Interrupt Controller (AIC)
  Individually Maskable, Eight-level Priority, Vectored Interrupt Sources
  Two External Interrupt Sources and One Fast Interrupt Source, Spurious Interrupt Protected
• Debug Unit (DBGU)
  2-wire UART and Support for Debug Communication Channel, Programmable ICE Access Prevention
• Periodic Interval Timer (PIT)
  20-bit Interval Timer plus 12-bit Interval Counter
• Watchdog Timer (WDT)
  Key-protected, Programmable Only Once, Windowed 16-bit Counter Running at Slow Clock
• Two Real-time Timers (RTT)
  32-bit Free-running Backup Counter Running at Slow Clock with 16-bit Prescaler
• Five 32-bit Parallel Input/Output Controllers (PIOA, PIOB, PIOC, PIOD and PIOE)
  160 Programmable I/O Lines Multiplexed with Up to Two Peripheral I/Os
  Input Change Interrupt Capability on Each I/O Line
  Individually Programmable Open-drain, Pull-up Resistor and Synchronous Output
• One Part 2.0A and Part 2.0B-compliant CAN Controller
  16 Fully-programmable Message Object Mailboxes, 16-bit Time Stamp Counter
• Two Multimedia Card Interface (MCI)
  SDCard/SDIO and MultiMediaCardCompliant
  Automatic Protocol Control and Fast Automatic Data Transfers with PDC
• Two SDCard Slots Support on eAch Controller
• Two Synchronous Serial Controllers (SSC)
  Independent Clock and Frame Sync Signals for Each Receiver and Transmitter
  I睸 Analog Interface Support, Time Division Multiplex Support
  High-speed Continuous Data Stream Capabilities with 32-bit Data Transfer
• One AC97 Controller (AC97C)
  6-channel Single AC97 Analog Front End Interface, Slot Assigner
• Three Universal Synchronous/Asynchronous Receiver Transmitters (USART)
  Individual Baud Rate Generator, IrDAInfrared Modulation/Demodulation, Manchester Encoding/Decoding
  Support for ISO7816 T0/T1 Smart Card, Hardware Handshaking, RS485 Support
• Two Master/Slave Serial Peripheral Interface (SPI)
  8- to 16-bit Programmable Data Length, Four External Peripheral Chip Selects
• One Three-channel 16-bit Timer/Counters (TC)
  Three External Clock Inputs, Two Multi-purpose I/O Pins per Channel
  Double PWM Generation, Capture/Waveform Mode, Up/Down Capability
• One Four-channel 16-bit PWM Controller (PWMC)
• One Two-wire Interface (TWI)
  Master Mode Support, All Two-wire AtmelEEPROMs Supported
• IEEE1149.1 JTAG Boundary Scan on All Digital Pins
• Required Power Supplies
  1.08V to 1.32V for VDDCORE and VDDBU

AT91SAM9263 订购型号

Ordering Code	Package	Package Type	Operating Temperature Range
AT91SAM9263-CU	TFBGA 324	Green	Industrial (-40° C to 85° C)

AT91SAM9263 应用技术支持与电子电路设计开发资源下载

1. AT91SAM9263 数据手册DataSheet 下载. PDF(完整版)
2. AT91SAM9263 数据手册DataSheet 下载. PDF（简洁版）
3. ARM7TDMI 技术白皮书
4. AT91SAM 系列产品选型指南(Brochure, 2 pages, revision E, updated 2/09)
   Product selection guide to Atmel's AT91SAM microcontrollers that give immediate access to market-leading ARM processors.
5. Atmel's ARM-based Microcontroller Excels in Real-Time (White Paper, 6 pages, revision A, updated 3/01)
   Applications such as mobile communicators, PDAs, solid-state music players and internet appliances demand the best possible real-time performance. Atmel's AT91 series of ARM-based microcontrollers incorporates a number of advanced features that enhance the real-time performance of the ARM7TDMI core, making it ideal for applications of this nature.