• 简体中文
• English

FDA4100LV：4x135W / 2x270W low voltage operation PWM digital input power amplifier with I2C diagnostics and step-up driver

The FDA4100LV is a new BCD- SOI (silicon on insulation) technology QUAD BRIDGE class D amplifier, specially intended for car radio applications.

Thanks to the technology used, it is possible to integrate a high performance D/A converter together with powerful MOSFET outputs in class D, to get an outstanding efficiency compared with the standard class AB.

The integrated D/A converter allows to reach outstanding performances (110 dB S/N ratio with 108 dB of dynamic range). The feedback loop includes the output L-C low-pass filter, allowing superior frequency response linearity and lower distortion independently of the inductor and capacitor quality.

FDA4100LV is fully configurable through I²C bus interface and integrates a full diagnostics array specially intended for automotive applications (with the status of each single speaker).Thanks to the solutions implemented to solve the EMI problems, the device is conceived to be used in the standard single DIN car-radio box together with the tuner.

The possibility to parallelize the outputs allows to drive both 2 Ω and 1 Ω speakers.A built-in step-up driver allows to provide high output power even using the standard 14 V supply voltage.

Moreover FDA4100LV is able to work down to 6 V supply, thus supporting the most recent low voltage ('start-stop') car-makers specification.

Key Features

• AEC-Q100 qualified
• Integrated 108 dB D/A conversion
• I2 S and TDM digital input (3.3/1.8 V)
• Input sampling frequency: 44.1kHz, 48 kHz, 96 kHz, 192 kHz
• MOSFET power outputs
• Step-up driver included
• EMI control for FM/AM compatibility
• EMI compliance at the CEI EN 55025 (2009-10)
• Dithering possibility
• Very low component count
• Output low-pass filter included in the feedback
• Low radiation function (LRF)
• High output power capability
  • 4 x 85 W/4 Ω @ 25 V, 1 kHz, 10% THD
  • 2 x 150 W/2 Ω @ 25 V, 1 kHz, 10% THD
• Max. output power
  • 4 x 135 W/4 Ω @ 25 V, 1 kHz
  • 2 x 270 W/2 Ω @ 25 V, 1 kHz
• Full I2 C bus driving (3.3/1.8 V):
  • Independent front/rear soft play/ mute
  • I2 C diagnostics (DC and AC load detection, internal test signal generated)
• Very flexible fault detection though integrated diagnostic
• Offset detector (play or mute mode)
• Four independent short circuit protection
• Clipping detector
• C-MOS compatible enable pin (3.3/5 V)
• ESD protection
• 6 V operation (“start - stop”)

产品规格

宣传册

选型指南

样片和购买

质量和可靠性