• 简体中文
• English

L99ASC03G：Brushless/Sensorless 3-phase motor pre-driver for automotive applications

The L99ASC03G is a multifunctional system IC designed for three-phase motor control applications.

The device features a voltage regulator to supply an external microcontroller and an operation amplifier for motor current sensing. It is designed to control six external N-channel MOSFETs in bridge configuration to drive three-phase motors in automotive applications. All gate driver outputs are controlled by separate inputs.

The integrated Serial Peripheral Interface (SPI) makes it possible to adjust device parameters, control all operating modes and read out diagnostic information.

Key Features

• AEC-Q100 qualified
• 5 V low-drop voltage regulator (200 mA continuous mode)
• Very low current consumption in standby mode (typ. 15 μA)
• ST SPI interface for control and diagnostics
• Window watchdog and fail-safe functionality
• Two separate power supply pins
• Three half-bridge drivers to control external MOSFETs (configurable by SPI)
• Full drive of external MOSFETs down to 6 V input voltage
• Input pin for each gate driver (with cross-current protection)
• Two-stage charge pump supporting 100% duty cycle
• PWM operation up to 80 kHz (not restricted)
• Current-sense amplifier (configurable by SPI)
• Disable input to turn off gate driver outputs
• Analog multiplexer output to monitor external power supply voltages and internal junction temperature
• Advanced BEMF detection IP
• Overcurrent protection (programmable)
• Drain-source monitoring and open-load detection
• TQFP48 7 x 7 x 1 mm with Exposed Pad (4.5 x 4.5 mm) package

产品规格

选型指南

样片和购买

质量和可靠性