STEF05：Electronic fuse for 5 V line
The STEF05 is an integrated electronic fuse optimized for monitoring output current and input voltage. Connected in series to a 5 V rail, it is capable of protecting the electronic circuitry on its output from overcurrent and overvoltage. The device has a controlled delay and turn-on time. When an overload condition occurs, the STEF05 limits the output current to a predefined safe value. If the anomalous overload condition persists, it goes into an open state, disconnecting the load from the power supply. If a continuous short-circuit is present on the board, when power is re-applied the E-fuse initially limits the output current to a safe value, and then again goes into an open state. The device is equipped with a thermal protection circuit. The intervention of the thermal protection is signalled to the board monitoring circuits through a signal on the Fault pin. Unlike mechanical fuses, which must be physically replaced after a single event, the E-fuse does not degrade in its performance after short-circuit/thermal protection interventions and it is reset either by recycling the supply voltage or using the Enable pin. The companion chip for 12 V power rails is also available with part number STEF12.
Key Features
- Continuous current (typ): 3.6 A
- N-channel on-resistance (typ): 40 mΩ
- Enable/Fault functions
- Output clamp voltage (typ): 6.65 V
- Undervoltage lockout
- Short-circuit limit
- Overload current limit
- Controlled output voltage ramp
- Thermal latch (typ): 165 °C
- Uses tiny capacitors
- Operating junction temp. - 40 °C to 125 °C
- Available in DFN10 (3x3 mm) package
产品规格
应用手册
选型指南
解决方案评估工具
| 型号 | 制造商 | Description |
|---|
| STEVAL-IFP021V1 | | 5 V and 12 V power line protection based on STEF05 and STEF12 electronic fuses |
样片和购买
| 型号 | Package | Packing Type | Unit Price (US$)
* | Quantity | ECCN (EU) | ECCN (US) | Country of Origin |
|---|
| STEF05PUR | VDFPN 10 3x3x1.0 | Tape And Reel | 0.596 | 1000 | NEC | EAR99 | CHINA |
质量和可靠性
