• 简体中文
• English

STEF12：Electronic fuse for 12 V line

The STEF12 is an integrated electronic fuse optimized for monitoring output current and input voltage. Connected in series to a 12 V rail, it is capable of protecting the electronic circuitry on its output from overcurrent and overvoltage. The device has a controlled delay and turn-on time. When an overload condition occurs, the STEF12 limits the output current to a predefined safe value. If the anomalous overload condition persists it goes into an open state, disconnecting the load from the power supply. If a continuous short-circuit is present on the board, when power is re-applied the E-fuse initially limits the output current to a safe value and then again goes into an open state. The device is equipped with a thermal protection circuit. The intervention of the thermal protection is signalled to the board monitoring circuits through a signal on the Fault pin. Unlike the mechanical fuses, which must be physically replaced after a single event, the E-fuse does not degrade in its performance after short-circuit/thermal protection interventions and it is reset either by recycling the supply voltage or using the Enable pin. The companion chip for the 5 V power rails is also available with part number STEF05.

Key Features

• Continuous current (typ): 3.6 A
• N-channel on-resistance (typ): 53 mΩ
• Enable/Fault functions
• Output clamp voltage (typ):15 V
• Undervoltage lockout
• Short-circuit limit
• Overload current limit
• Controlled output voltage ramp
• Thermal latch (typ): 165 °C
• Uses tiny capacitors
• Operating junction temp. - 40 °C to 125 °C
• Available in DFN10 (3x3 mm) package

产品规格

应用手册

选型指南

解决方案评估工具

样片和购买

质量和可靠性