AP3891：Touch Screen Controllers
| Part Number | Data Sheet | SPICE Model | VDD (V) | Max Channels(Driving x Sensing) | Target Panel Size (") | Max TouchPoints | ADC Resolution (bits) | Flash | Interface |
|---|---|---|---|---|---|---|---|---|---|
| AP3891 | AP389X.pdf | - | 2.8 to 3.6 | 60 (38 x 22) | 8 to 13 | 10 | 10 | 64KB | I2C |
Description
The AP389X is a low-cost high-resolution single chip solution for APA capacitive touch screen. It is an 8-bit single cycle 8051 microcontroller with I2C Interface. The chip includes 8-bit successive approximation analog-to-digital converters with an I2C interface and multiplexer-switcher circuits for flexible measurement of analog signal from APA panel. An accurate switched-capacitor integrator is built-in and it can auto calibrate the pixel parameters for a wide range of capacitance on the touch screen (0.1pF to 4pF). On-chip capacitor can replace external component. This touch screen controller (TSC) with CMOS integration circuit provides an ideal choice for APA touch panel. The AP389X is specified over the temperature range of -40°C to 95°C.
Application
- Mobile Phones
- Personal Digital Assistants
- Smart Hand-held or Gaming Devices
Features
- Mutual Capacitive Touch Sensing
- Dual Power Supply: 2.8V to 3.6V Operation Voltage; 1.6V to 2.0V Operation Voltage
- Up to 30/38/36 Drive Lines and 17/22/23 Sense Lines
- Dedicated Internal Two-wire Serial Control Bus I2C and UART between AP389X and Host
- Single-end Integrator with Programmable Gain Control and Offset Control
- Multiplexed Analog Digitization with Two 8-bit Resolution Odd/Even Scan SAR ADCs and Its Dedicated 2X to 8X Accumulator XSRAM Buffers
- Single Cycle 8051 CPU Core, Maximum Operating Clock up to 24MHz from IOSC (Zero Wait State); 48MHz from IOSC(With Wait State) - 4MHz to 48MHz Internal Oscillator (IOSC) - 64K-byte Flash ROM - 256-byte Internal SRAM and 12032-byte XSRAM Extra XSRAMs for AFE: - 896×12-bit×2 XSRAM for 8-bit SAR ADC - 896×8-bit XSRAM for 8-bit Parasitical Capacitor Compensator Two 16-bit Timers T0/T1 and One 16-bit ECT Timer T2 One I2C Slave Controller and One I2C Master Controller Shared with the Same Port - With Asynchronous I2C Slave Address Detection Logic Design - 4 General Purpose GPIO Pins - One External Interrupt Pin - One UART Data Transfer Output Pin
- ISP/IAP via I°C Port
- Operation Temperature Range: -40°C to 95°C
- Package Types: QFN-7×7-56 and QFN-8Ω8-68
- RoHS Compliance
U-QFN8080-68
- AP389X.pdf AP3892
