PAM2863:Medium Voltage DC-DC LED Drivers

Part NumberData SheetSPICE ModelQualified to AECQ10xPPAP CapableTopologies (Buck)Topologies (Buck-Boost)Topologies (Boost)MinimumInput Voltage (V)MaximumInput Voltage (V)Maximum Output Voltage (V)Maximum LED Current (A)LED Current Accuracy (%)Switching Frequency Maximum (kHz)Dimming (PWM)Dimming (Analog)Efficiency (%)OperatingTemperatureRange (°C)Sense Voltage (mV)AEC-Q100 Grade
PAM2863PAM2863.pdf---Yes--4.54040251000YesYes97-40 to +85100-
Description

The PAM2863 is a continuous mode inductive step-down converter, designed for driving single or multiple series connected °Cs efficiently from a voltage source higher than the °C voltage. The device operates from an input supply between 4.5V and 40V and provides an externally adjustable output current of up to 2A. Depending upon supply voltage and external components, this can provide up to 30 watts of output power. The PAM2863 includes the output switch and a high-side output current sensing circuit, which uses an external resistor to set the nominal average output current. Output current can be adjusted below the set value, by applying an external control signal to the VSET pin. The VSET pin will accept either a DC voltage or a PWM waveform. The soft-start time can be increased using an external capacitor from the VSET pin to ground. Applying a voltage of 0.2V or lower to the VSET pin turns the output off and switches the device into a low current standby state.

Application
  • High End LED Flashlight
  • LED Light Bar
Features
  • Simple Low Parts Count
  • Internal 40V NDMOS Switch
  • 2A Output Current
  • Single Pin On/Off and Brightness Control Using DC Voltage or PWM
  • Soft-Start
  • High Efficiency (up to 97%)
  • Wide Input Voltage Range: 4.5V to 40V
  • Output Shutdown
  • Open °C Protection
  • Short °C Protection
  • Up to 1MHz Switching Frequency
  • Typical 5% Output Current Accuracy
  • Pb-Free SOP-8(EP) Packages
Ordering Information
  • PAM2863ECR
  • PAM2863EV1
SO-8EP
PAM2863.pdf PAM2863