ZXLD1615：LED Drivers for Displays / Backlights
| Part Number | Data Sheet | SPICE Model | Function | MinimumInput Voltage (V) | MaximumInput Voltage (V) | Maximum Output Voltage (V) | Number of Regulated Output Channels | Maximum Output Current per Channel (mA) | Typical Over-Current Protection Current (mA) | Switching Frequency (MHz) | Efficiency (%) | Quiescent Current (mA) | Standby Quiescent Current (µA) | SW RDS(ON) (Ω) | Dimming | OVP | Soft Start | VFB (V) | OperatingTemperatureRange (°C) |
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ZXLD1615 | ZXLD1615.pdf | - | LCD/OLED Bias Generator | 2.7 | 5.5 | 28 | 1 | - | 320 | 0.35 | 85 | 0.06 | 1 | 1.75 | - | No | No | 1.25 | -40 to +85 |
Description
The ZXLD1615 is a PFM inductive boost converter designed to provide output voltages of up to 28V from a 2.5V to 5.5V input supply. The ZXLD1615 includes the output switch and peak current sense resistor, and can provide up to 10mA output current at maximum output voltage. Higher current is available at lower output voltages. Quiescent current is typically 60μA and a shutdown function is provided to reduce this current to less than 100nA in the 'off' state. Nominal output voltage can be set up to a maximum of 28V by two external resistors and can be adjusted to lower values by a PWM control signal applied to the 'Enable' pin. Depending upon the control frequency, the PWM signal will provide either continuous (low ripple) or gated control. The PWM filter components are contained within the chip. Minimum output voltage is determined by the input supply. The device is assemb°C in a low profile TSOT25 pin package.
Application
- LCD and OLED bias
- Cellular / mobile phones
- Digital cameras
- PDAs
- LCD modules
- Varactor and PIN diode bias
- Palmtop computers
Ordering Information
- ZXLD1615ET5TA
TSOT25
- ZXLD1615.pdf ZXLD1615
