• 简体中文
• English

MAX126：2x4-Channel, Simultaneous-Sampling, 14-Bit DAS

First 14-Bit, 8-Channel, Simultaneous-Sampling ADC for Industrial Applications

The MAX125/MAX126 are high-speed, multichannel, 14-bit data-acquisition systems (DAS) with simultaneous track/holds (T/Hs). These devices contain a 14-bit, 3µs, successive-approximation analog-to-digital converter (ADC), a +2.5V reference, a buffered reference input, and a bank of four simultaneous-sampling T/H amplifiers that preserve the relative phase information of the sampled inputs. The MAX125/MAX126 have two multiplexed inputs for each T/H, allowing a total of eight inputs. In addition, the converter is overvoltage tolerant to ±17V; a fault condition on any channel will not harm the IC. Available input ranges are ±5V (MAX125) and ±2.5V (MAX126). An on-board sequencer converts one to four channels per active-low CONVST pulse. In the default mode, one T/H output (CH1A) is converted. An interrupt signal (active-low INT) is provided after the last conversion is complete. Convert two, three, or four channels by reprogramming the MAX125/MAX126 through the bidirectional parallel interface. Once programmed, the MAX125/MAX126 continue to convert the specified number of channels per active-low CONVST pulse until they are reprogrammed. The channels are converted sequentially, beginning with CH1. The INT signal always follows the end of the last conversion in a conversion sequence. The ADC converts each assigned channel in 3µs and stores the result in an internal 14x4 RAM. Upon completion of the conversions, data can be accessed by applying successive pulses to the active-low RD pin. Four successive reads access four data words sequentially. The parallel interface's data-access and bus-release timing specifications are compatible with most popular digital signal processors and 16-bit/32-bit microprocessors, so the MAX125/MAX126 conversion results can be accessed without resorting to wait states.

Key Features Four Simultaneous-Sampling T/H Amplifiers with Two Multiplexed Inputs (eight single-ended inputs total) 3µs Conversion Time per Channel Throughput: 250ksps (1 channel) 142ksps (2 channels) 100ksps (3 channels) 76ksps (4 channels) Input Range: ±5V (MAX125) ±2.5V (MAX126) Fault-Protected Input Multiplexer (±17V) ±5V Supplies Internal +2.5V or External Reference Operation Programmable On-Board Sequencer High-Speed Parallel DSP Interface

MAX125, MAX126: Typical Operating Circuit Applications/Uses Digital Signal Processing (DSP) Multiphase Motor Control Power-Factor Monitoring Power-Grid Synchronization Vibration and Waveform Analysis

DataSheet

Parametrics

Design kits & evaluation modules

• MAX125EVKIT
• MAX126EVKIT

Related Products

• MAX11058：4-/6-/8-Channel, 16-/14-Bit, Simultaneous-Sampling ADCs
• MAX11056：4-/6-/8-Channel, 16-/14-Bit, Simultaneous-Sampling ADCs
• MAX126：2x4-Channel, Simultaneous-Sampling, 14-Bit DAS

Ordering Information