• 简体中文
• English

MAX3098E：±15kV ESD-Protected, 32Mbps, 3V/5V,Triple RS-422/RS-485 Receivers with Fault Detection

The MAX3097E/MAX3098E feature three high-speed RS-485/RS-422 receivers with fault-detection circuitry and fault-status outputs. The receivers' inputs have fault thresholds that detect when the part is not in a valid state. The MAX3097E/MAX3098E indicate when a receiver input is in an open-circuit condition, short-circuit condition, or outside the common-mode range. They also generate a fault indication when the differential input voltage goes below a preset threshold. See Ordering Information or the Electrical Characteristics in the full data sheet for threshold values. The fault circuitry includes a capacitor-programmable delay to ensure that there are no erroneous fault conditions even at slow edge rates. Each receiver is capable of accepting data at rates up to 32Mbps.

Key Features Detects the Following RS-485 Faults: Open-Circuit Condition Short-Circuit Condition Low Differential Voltage Signal Common-Mode Range Violation ESD Protection ±15kV—Human Body Model ±15kV—IEC 1000-4-2, Air-Gap Discharge Method ±8kV—IEC 1000-4-2, Contact Discharge Method Single +3V to +5.5V Operation -10V to +13.2V Extended Common-Mode Range Capacitor-Programmable Delay of Fault Indication Allows Error-Free Operation at Slow Data Rates Independent and Universal Fault Outputs 32Mbps Data Rate 16-Pin QSOP is 40% Smaller than Industry-Standard 26LS31/32 Solutions

MAX3097E, MAX3098E: Typical Application Circuit Applications/Uses Embedded Systems High-Speed, Triple RS-485/RS-422 Receiver with Extended Electrostatic Discharge (ESD) RS-485/RS-422 Receivers for Motor-Shaft Encoders Telecommunications Triple RS-485/RS-422 Receiver with Input Fault Indication

DataSheet

Parametrics

Quality and Environmental Data

• MAX3098E.pdf

Ordering Information