• 简体中文
• English

MAX9892：Shunt Mode Audio Click-and-Pop Eliminator

Industry's Newest IC Eliminates Clicks and Pops for Headphone and Line Output in a Small Footprint

The MAX9892 is an audio click-and-pop eliminator for portable multimedia devices. Operating from a 1.7V to 3.6V supply, the MAX9892 connects to the output of the existing system amplifier and provides a low-impedance path to ground during startup and shutdown. The inputs INL and INR accept voltage swings from VDD to 5.5V below VDD. See the Setting the Supply Voltage section in the full data sheet for more information. The power-up and power-down transients are shunted to ground to prevent clicks and pops from becoming audible. The MAX9892 features two low-impedance analog switches controlled by active-low MUTE that opens and closes the switches. The switches are open during normal operation and have no impact on the output signal. During startup and shutdown of the amplifier, the MAX9892 can be activated to short the outputs to ground and prevent clicks and pops from pulling current through the headphones. The MAX9892 is available in 6-bump UCSP™ (1mm x 1.52mm x 0.6mm) and 6-pin µDFN (2mm x 2mm x 0.75mm) packages. The MAX9892 is specified over the -40°C to +85°C temperature range.

Key Features Distortion-Free, Click-and-Pop Elimination Less than 1µA Supply Current 1.7V to 3.6V Single-Supply Operation Tiny Packages 6-Bump UCSP (1mm x 1.52mm x 0.6mm) 6-Pin µDFN (2mm x 2mm x 0.75mm)

MAX9892: Typical Operating Circuit Applications/Uses Mobile Internet Devices Mobile Phones Notebook Computers Portable Gaming Consoles Portable Media Players Smart Phones

DataSheet

Parametrics

Design kits & evaluation modules

• MAX9892EVKIT

Quality and Environmental Data

• MAX9892.pdf

Ordering Information