• 简体中文
• English

MAX9981：825MHz to 915MHz, Dual SiGe High-Linearity Active Mixer

Industry's First Dual SiGe Mixer Reduces Cost, Space, and Component Count for 2.5G and 3G BTS Designs

The MAX9981 dual high-linearity mixer integrates a local oscillator (LO) switch, LO buffer, LO splitter, and two active mixers. On-chip baluns allow for single-ended RF and LO inputs. The active mixers eliminate the need for an additional IF amplifier because the mixer provides a typical overall conversion gain of 2.1dB. The MAX9981 active mixers are optimized to meet the demanding requirements of GSM850, GSM900, and CDMA850 base-station receivers. These mixers provide exceptional linearity with an input IP3 of greater than +27dBm. The integrated LO driver allows for a wide range of LO drive levels from -5dBm to +5dBm. In addition, the built-in high-isolation switch enables rapid LO selection of less than 250ns, as needed for GSM transceiver designs. The MAX9981 is available in a 36-pin QFN package (6mm x 6mm) with an exposed paddle, and is specified over the -40°C to +85°C extended temperature range.

Key Features +27.3dBm Input IP3 +13.6dBm Input 1dB Compression Point 825MHz to 915MHz RF Frequency Range 70MHz to 170MHz IF Frequency Range 725MHz to 1085MHz LO Frequency Range 2.1dB Conversion Gain 10.8dB Noise Figure 42dB Channel-to-Channel Isolation -5dBm to +5dBm LO Drive +5V Single-Supply Operation Built-In LO Switch with 52dB LO1 to LO2 Isolation ESD Protection Integrated RF and LO Baluns for Single-Ended Inputs

MAX9981: Pin Configuration Applications/Uses Cellular cdmaOne™ and cdma2000® Base Station Receivers Digital and Spread-Spectrum Communication Systems GSM 850/GSM 900 2G and 2.5G EDGE Base Station Receivers Microwave Point-to-Point Links TDMA and Integrated Digital Enhanced Network (iDEN®) Base-Station Receivers

DataSheet

Parametrics

Design kits & evaluation modules

• MAX9981EVKIT

Related Products

• MAX9982：825MHz to 915MHz, SiGe High-Linearity Active Mixer

Ordering Information