The 'LVTH16245A devices are 16-bit (dual-octal) noninverting 3-state transceivers designed for low-voltage (3.3-V) VCC operation, but with the capability to provide a TTL interface to a 5-V system environment.
The devices are designed for asynchronous communication between two data buses. The logic levels of the direction-control (DIR) input and the output-enable (OE) input activate either the B-port outputs or the A-port outputs or place both output ports into the high-impedance mode. The device transmits data from the A bus to the B bus when the B-port outputs are activated, and from the B bus to the A bus when the A-port outputs are activated. The input circuitry on both A and B ports is always active and must have a logic HIGH or LOW level applied to prevent excess ICC and ICCZ.
Active bus-hold circuitry holds unused or undriven inputs at a valid logic state. Use of pullup or pulldown resistors with the bus-hold circuitry is not recommended.
When VCC is between 0 and 1.5 V, the devices are in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 1.5 V, OE should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
These devices are fully specified for hot-insertion applications using Ioff and power-up 3-state. The Ioff circuitry disables the outputs, preventing damaging current backflow through the devices when they are powered down. The power-up 3-state circuitry places the outputs in the high-impedance state during power up and power down, which prevents driver conflict
| SN54LVTH16245A-SP | |
| Voltage Nodes (V) | 3.3, 2.7 |
| Vcc range (V) | 2.7 to 3.6 |
| Input Level | TTL/CMOS |
| Output Level | LVTTL |
| Output Drive (mA) | -24/48 |
| No. of Outputs | 16 |
| No. of Bits | 16 |
| Logic | True |
| Static Current | 5 mA |
| tpd max (ns) | 4.5 |
| Rating | Space |
| Technology Family | LVT |
| 器件 | 状态 | 温度 | 价格（美元） | 封装 | 引脚 | 封装数量 | 封装载体 | 丝印标记 |
| 5962-9668601VXA | ACTIVE | -55 to 125 | 182.75 | 1ku | CFP (WD) | 48 | 1 | TUBE |
| 器件 | 环保计划* | 铅/焊球涂层 | MSL 等级/回流焊峰 | 环保信息与无铅 (Pb-free) | DPPM / MTBF / FIT 率 |
| 5962-9668601VXA | TBD | Call TI | N/A for Pkg Type | 5962-9668601VXA | 5962-9668601VXA |