TCA9535 具有中断输出和配置寄存器的远程 16 位 I2C 和 SMBus 低功耗 I/O 扩展器

This 16-bit I/O expander for the two-line bidirectional bus (I2C) is designed for 1.65-V to 5.5-V VCC operation. It provides general-purpose remote I/O expansion for most microcontroller families via the I2C interface [serial clock (SCL), serial data (SDA)].

The TCA9535 consists of two 8-bit Configuration (input or output selection), Input Port, Output Port, and Polarity Inversion (active-high or active-low operation) registers. At power on, the I/Os are configured as inputs. The system master can enable the I/Os as either inputs or outputs by writing to the I/O configuration bits. The data for each input or output is kept in the corresponding Input or Output Port register. The polarity of the Input Port register can be inverted with the Polarity Inversion register. All registers can be read by the system master.

The system master can reset the TCA9535 in the event of a timeout or other improper operation by utilizing the power-on reset feature, which puts the registers in their default state and initializes the I2C/SMBus state machine.

The TCA9535 open-drain interrupt (INT) output is activated when any input state differs from its corresponding Input Port register state and is used to indicate to the system master that an input state has changed.

INT can be connected to the interrupt input of a microcontroller. By sending an interrupt signal on this line, the remote I/O can inform the microcontroller if there is incoming data on its ports without having to communicate via the I2C bus. Thus, the TCA9535 can remain a simple slave device.

The device outputs (latched) have high-current drive capability for directly driving LEDs. The device has low current consumption.

Although pin-to-pin and I2C address compatible with the PCF8575, software changes are required due to the enhancements.

The TCA9535 is identical to the PCA9555, except for the removal of the internal I/O pullup resistor, which greatly reduces power consumption when the I/Os are held low.

Three hardware pins (A0, A1, and A2) are used to program and vary the fixed I2C address and allow up to eight devices to share the same I2C bus or SMBus. The fixed I2C address of the TCA9535 is the same as the PCA9555, PCF8575, PCF8575C, and PCF8574, allowing up to eight of these devices in any combination to share the same I2C bus or SMBus

TCA9535
Interrupt Output Yes  
Pin/Package 24TSSOP, 24QFN  
Operating Temperature Range(°C) -40 to 85  
Max Frequency(kHz) 400  
I2C Address 0100 xxx  
# of I/Os 16  
Vcc range(V) 1.65 to 5.5  
Low Power Yes  
Configuration Registers Yes  
5V Tolerant I/O Yes  
Push–Pull I/O Type Yes
TCA9535 特性
TCA9535 芯片订购指南
器件 状态 温度 价格 封装 | 引脚 封装数量 | 封装载体 丝印标记
TCA9535PWR ACTIVE -40 to 85 1.00 | 1ku TSSOP (PW) | 24 2000 | LARGE T&R  
TCA9535RTWR ACTIVE -40 to 85 1.00 | 1ku QFN (RTW) | 24 3000 | LARGE T&R  
TCA9535 质量与无铅数据
器件 环保计划* 铅/焊球涂层 MSL 等级/回流焊峰 环保信息与无铅 (Pb-free) DPPM / MTBF / FIT 率
TCA9535PWR Green (RoHS & no Sb/Br)  CU NIPDAU  Level-1-260C-UNLIM TCA9535PWR TCA9535PWR
TCA9535RTWR Green (RoHS & no Sb/Br)  CU NIPDAU  Level-2-260C-1 YEAR TCA9535RTWR TCA9535RTWR
TCA9535 应用技术支持与电子电路设计开发资源下载
  1. TCA9535 数据资料 dataSheet 下载.PDF
  2. TI 德州仪器I2C 逻辑器件产品选型与价格 . xls
  3. Logic Guide 2009 (PDF 4263 KB)
  4. Shelf-Life Evaluation of Lead-Free Component Finishes (PDF 1305 KB)
  5. Understanding and Interpreting Standard-Logic Data Sheets (PDF 857 KB)
  6. TI IBIS File Creation, Validation, and Distribution Processes (PDF 380 KB)
  7. Implications of Slow or Floating CMOS Inputs (PDF 101 KB)
  8. CMOS Power Consumption and CPD Calculation (PDF 89 KB)
  9. Designing With Logic (PDF 186 KB)
  10. Live Insertion (PDF 150 KB)
  11. Input and Output Characteristics of Digital Integrated Circuits (PDF 1708 KB)
  12. Using High Speed CMOS and Advanced CMOS in Systems With Multiple Vcc (PDF 43 KB)
  13. HiRel Unitrode Power Management Brochure (PDF 206 KB)
  14. LOGIC Pocket Data Book (PDF 6001 KB)
  15. HiRel Unitrode Power Management Brochure (PDF 206 KB)
  16. Logic Cross-Reference (PDF 2938 KB)