STWD100 Watchdog
The STWD100 watchdog timer circuits are self-contained devices which prevent system failures that are caused by certain types of hardware errors (non-responding peripherals, bus contention, etc.) or software errors (bad code jump, code stuck in loop, etc.).
The STWD100 watchdog timer has an input, WDI, and an output, WDO. The input is used to clear the internal watchdog timer periodically within the specified timeout period, twd. While the system is operating correctly, it periodically toggles the watchdog input, WDI. If the system fails, the watchdog timer is not reset, a system alert is generated and the watchdog output, WDO, is asserted.
The STWD100 circuit also has an enable pin, EN, which can enable or disable the watchdog functionality. The EN pin is connected to the internal pull-down resistor. The device is enabled if the ENpin is left floating
技术特性
- Current consumption 13 μA typ.
- Available watchdog timeout periods are 3.4 ms, 6.3 ms, 102 ms and 1.6 s
- Chip enable input
- Open drain or push-pull WDOoutput
- Operating temperature range: –40 to +125 °C
- Package SOT23-5, SC70-5 (SOT323-5)
|
功能框图
 |
STWD100 订购信息
| 订购型号 |
产品状态 |
美金价格 |
数量 |
封装 |
包装形式 |
温度范围 |
材料声明 |
| STWD100NYWY3F |
Active |
0.2804 |
1000 |
SOT23-5L |
Tape And Reel |
–40 to +125 °C |
STWD100NYWY3F |
| STWD100NPWY3F |
Active |
0.2804 |
1000 |
SOT23-5L |
Tape And Reel |
–40 to +125 °C |
STWD100NPWY3F |
DATASHEET
| 描述 |
版本 |
大小 |
| STWD100 : DS5579: Watchdog timer circuit |
6 |
271KB |
FLYERS
