AT49F1024A 1Mbit,Flash存储器
| Density | 1M |
| Organization | 64K x 16 |
| Speed | 45 ns |
| Vcc (V) | 4.5 |
| Pb-Free Packages |
VSOP 40 |
1M bit (64K x 16), 5-Volt Read and 5-Volt Write Flash
The AT49F1024A is a 5-volt-only in-system Flash memory organized as 65,536 words by 16 bits. Manufactured with Atmel’s advanced nonvolatile CMOS technology, the devices offer access times to 45 ns with power dissipation of just 275 mW over the commercial temperature range. When the device is deselected, the CMOS standby current is less than 100 μA. To allow for simple in-system reprogrammability, the AT49F1024A does not require high-input voltages for programming. Five-volt-only commands determine the read and programming operation of the device. Reading data out of the device is similar to reading from an EPROM. Reprogramming the AT49F1024A is performed by erasing a block of data (entire chip or main memory block) and then programming on a word-byword basis. The typical word programming time is a fast 10 μs. The end of a program cycle can be optionally detected by the Data Polling feature. Once the end of a byte program cycle has been detected, a new access for a read or program can begin. The typical number of program and erase cycles is in excess of 10,000 cycles.
AT49F1024A 特性
- Single-voltage Operation
– 5V Read
– 5V Reprogramming - Fast Read Access Time – 45 ns
- Internal Program Control and Timer
- 8K Word Boot Block with Lockout
- Fast Erase Cycle Time – 1.5 seconds
- Word-by-word Programming – 10 μs/Word Typical
- Hardware Data Protection、
- Data Polling for End of Program Detection
- Small 10 x 14 mm VSOP Package
- Typical 10,000 Write Cycles
AT49F1024A 订购型号
| tACC (ns) |
ICC (mA) | Ordering Code | Package | Operation Range | |
| Active | Standby | ||||
| 45 | 50 | 0.1 | AT49F1024A-45VC | 40V | Commercial (-40° to 85° C) |
| AT49F1024A-45VL | |||||
AT49F1024A 应用技术支持与电子电路设计开发资源下载
- ATMEL 爱特梅尔Flash 存储器AT49F1024A 数据手册DataSheet 下载. PDF（PDF 文件格式完整版）
- 并行Flash 产品选型指南（
Excel 文档格式） - ATMEL 爱特梅尔公司全线产品目录. pdf
