• 简体中文
• English

DS28E10：1-Wire SHA-1 Authenticator

Provides Low-Cost, World-Class Authentication Security to Protect Your Development Investment

The DS28E10 combines secure challenge-and-response authentication functionality based on the FIPS 180-3 specified Secure Hash Algorithm (SHA-1) with 224 bits of one-time programmable user EPROM in a single chip. Once written, the memory is automatically write protected. Additionally, each device has its own guaranteed unique 64-bit ROM identification number (ROM ID) that is factory programmed into the chip. Memory writes are performed 4 bytes at a time. A secure and low-cost factory programming service is available to preprogram device data, including the SHA-1 security data components. The device communicates over the single-contact 1-Wire® bus. The communication follows the standard 1-Wire protocol with the ROM ID acting as node address in the case of a multidevice 1-Wire network.

Key Features Dedicated Hardware-Accelerated SHA-1 Engine for Generating SHA-1 MACs One Page of 28-Byte User OTP EPROM Irreversible Write Protection Unique Factory-Programmed 64-Bit Identification Number 1-Wire Interface for Standard and Overdrive Speeds Communicates with Host at Up to 15.4kbps at Standard Speed or Up to 125kbps in Overdrive Mode Operating Range from 2.8V to 3.6V, -40°C to +85°C 3-Lead SOT23 and 6-Lead TSOC Packages ±6kV Human Body Model (HBM) ESD Protection (typ) on the 1-Wire and VCC Pin

DS28E10: Typical Operating Circuit Applications/Uses Reference Design License Management Sensor/Accessory Authentication and Calibration System Intellectual Property Protection

DataSheet

Parametrics

Design kits & evaluation modules

• DS28E10EVKIT

Quality and Environmental Data

• DS28E10.pdf

Related Products

• DS28E02：1-Wire SHA-1 Authenticated 1Kb EEPROM with 1.8V Operation
• DS2460：SHA-1 Coprocessor with EEPROM
• DS2482-100：Single-Channel 1-Wire Master

Ordering Information